Download - Brunswick
Download - Brunswick
Download - Brunswick
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
VPS Camera<br />
The VPS uses two cameras to obtain pin information. One camera is dedicated<br />
to the left lane while the other is dedicated to the right one. The cameras are<br />
designed so that they can be easily as replaced as a complete unit.<br />
After replacing the camera(s) no physical alignment is necessary. All that is<br />
required, is triggering a calibration for the new camera.<br />
To replace the camera perform the following procedure:<br />
1. Disconnect the incoming power cable connected at J9 VPS Unit.<br />
2. Remove the cover from the VPS chassis.<br />
3. Disconnect the camera video cables from connectors J4 and J8 of the<br />
Logic PCB.<br />
4. Remove the 4 Phillips head screws located at the front of the VPS.<br />
5. Remove the Camera assembly.<br />
6. Reverse steps 1 - 5 to reinstall the new cameras.<br />
7. Calibrate the VPS.<br />
VPS Setup and Calibration<br />
Three steps are required to configure the VPS. First, the lane pair<br />
configuration must be entered through the scorer console. Second the<br />
information entered must be stored in the VPS. And finally the VPS must be<br />
calibrated. These steps can be accomplished through the maintenace menu of<br />
the scorer and the calibration buttons at the front of the VPS chassis.<br />
VPs Setup - Scorer Console<br />
Setup and troubleshooting for the VPS is accomplished through various menu<br />
selections available at the Frameworx console maintenance menu. To access<br />
the VPS maintenance menu enter the scorer maintenance menu as follows:<br />
1. Enter Maintenance Menu (6167254966 Default)<br />
2. Select Diagnostics<br />
3. Enter diagnostics password (33334)<br />
4. Select option VPS Menu to display the following menu selections:<br />
Video Pinsensing System 13