No. 94-08-19 - City of Frisco

More documents

Recommendations

Info

property owner or his engineer shall submit filing fees and the required number of copies for filing to the Planning Department for filing with the County. Having submitted all copies and fees, the owner may request a delay of filing for up to six (6) months from the date of approval. Any conveyance plat which has not been filed with the County within six (6) months of the date of approval shall be void. Prior to filing with the County, the property owner may withdraw and void a conveyance plat. Any conveyance plat withdrawn and/or voided must be resubmitted under current regulations and procedures and reapproved by the City Council and filed with the County. One (1) copy of the recorded conveyance plat will be forwarded to the property owner by the City Engineer. 2. No final plat processed and approved in association with a conveyance plat shall be filed without the concurrent filing of the associated approved conveyance plat. e. Effect - 1. Conveyance plat approval and acceptance by the City does not relieve the owner from obligations, including fees, required by other sections of this or other ordinances of the City pertaining to the improvement of the property or extension of services as required to make the property suitable for development. 2. Neither reservation nor dedication of right-of-way shall relieve the property owner from obligations for street construction or assessments associated with public street improvement programs. Easements for access, utilities and drainage may be recorded on conveyance plats. 3. Final Platting Requirements a. No building permits shall be issued nor permanent utility service provided for land which has only received approval as a conveyance plat. Notwithstanding the above, the Building Official may authorize temporary building permits, temporary occupancy permits, and temporary utility service. b. A conveyance plat may be superseded by a preliminary plat or final plat in total or in part through compliance with the procedures and requirements of this ordinance. 4-12
5.01 PRELIMINARY PLAT SECTION 5 PLAT FORM AND CONTENT The preliminary plat shall be drawn to a scale not smaller than two hundred (200) feet to the inch, and contain the following information: 1. Existing Features Inside Subdivision a. The existing boundary lines (accurate in scale) of the land to be subdivided. Boundary lines shall be drawn in heavy lines for easy identification. b. The location of existing water courses, railroads, and other similar drainage and transportation features. c. The location and width of existing streets and alley right-of-way, easements, buildings and structures, sewers, water mains, culverts or other underground structures within or adjacent to the tract. d. Topographical information with contour lines at two-foot (2') intervals, unless otherwise permitted by City Staff due to conditions of terrain involved. All elevations shall be referred to a Geodetic Survey or a City Survey. 2. Existing Features Outside Subdivision a. The name and property lines of adjoining property owners. b. The name and location of adjacent subdivisions, streets, easements, pipe lines, water courses, etc. c. All lines outside of subdivision boundaries to be dashed lines. 3. New Features Inside of Subdivision a. The proposed name of the subdivision. b. The location, right-of-way width, and names of proposed streets. c. The approximate width and depth of all lots. If the side lines are not parallel, the approximate distance between them at the building line and at the narrowest point should be given. d. The location of building lines, alleys and easements. e. The location and approximate size of sites for schools, churches, parks, including commercial retail, industrial, office, multi-family, educational, medical, and other special land uses. f. The approximate acreage of the property to be subdivided, and the number of lots. g. A proposed conceptual plan of all utilities (including size) to be constructed in the subdivision. 5-1
Page 1: City of Frisco Subdivision Regulati
Page 4 and 5: SUBDIVISION REGULATIONS OF THE CITY
Page 6 and 7: SUBDIVISION REGULATIONS OF THE CITY
Page 8 and 9: SECTION 2 DEFINITIONS 2.01 City or
Page 10 and 11: 3.01 AUTHORITY SECTION 3 PURPOSE, A
Page 12 and 13: a. Act within thirty (30) days afte
Page 14 and 15: 1) For plats located within the Cor
Page 16 and 17: 2. Procedure for Replats 1. Subdivi
Page 18 and 19: plat; d. To indicate monuments set
Page 20 and 21: subdivision of property in the foll
Page 24 and 25: 2. Key Mao A key map showing relati
Page 26 and 27: a. Accompanying the final plat shal
Page 28 and 29: (property description to be provide
Page 30 and 31: • said easements. The City of Fri
Page 32 and 33: • f. A Certificate of Approval sh
Page 34 and 35: means of access, the City may accep
Page 36 and 37: 3. All amenities placed on land ded
Page 38 and 39: 17. Size of buildings; 18. Computat
Page 40 and 41: . Local Thoroughfares - (Type F, Lo
Page 42 and 43: 7.03 LOTS 16. Reserve Strips Reserv
Page 44 and 45: Where lots have frontage on more th
Page 46 and 47: in length or of such greater distan
Page 48 and 49: • b. A maximum of forty percent (
Page 50 and 51: a. Residential - Six inch (6") thic
Page 52 and 53: d. A marker shall be installed at t
Page 54 and 55: • 1. Lights shall be placed in th
Page 56 and 57: 2. Where residential lots must dire
Page 58 and 59: agreement defining, among other thi
Page 60 and 61: • feet (60') to eighty feet (80')
Page 62 and 63: landscaping required by the Subdivi
Page 64 and 65: e. A five-foot (5') wall maintenanc
Page 66 and 67: • 2. Landscaping Requirements. La
Page 68 and 69: Exhibit #1 for 7.09 (15) Single-Fam
Page 70 and 71: -.4 Exhibit #3 or 7.09 (15) Single-
Page 72 and 73:
c. adjacent street. An opening shal
Page 74 and 75:
3. Parks and Playgrounds The locati
Page 76 and 77:
SECTION 8 FILING FEES AND CHARGES 8
Page 78 and 79:
:3.01 SECTION REPEAL -ft APPROVAL O
Page 80 and 81:
SUBDIVISION ORDINANCE CITY OF FRISC
show all

No. 94-08-19 - City of Frisco

Create successful ePaper yourself

Delete template?

Save as template?