AccuTouch Product Guide - Elo TouchSystems
AccuTouch Product Guide - Elo TouchSystems
AccuTouch Product Guide - Elo TouchSystems
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
External Controllers<br />
Installing the 2210MX Serial Controller<br />
Using the 2210MX external serial controller may simplify the overall<br />
integration process.<br />
Begin by deciding where to mount the controller on the rear of the display case.<br />
The dimensions of the enclosure are 4.14 in x 2.34 in x 0.9 in. Provide room for<br />
easy access and installation of all cables.<br />
Complete the following steps to install the controller:<br />
1 After choosing a location, drill a 0.625-inch diameter hole for cabling exiting<br />
the display and drill two holes for screws that will be mounted in the display<br />
case.<br />
2 After you drill the holes, route the transient suppression cable<br />
(P/N 484815-000) out through the 0.625-inch diameter hole in the display<br />
case.<br />
Note: Transient suppression cables should always be used unless you are using an LCD<br />
display.<br />
3 Attach the 1x5F connector on the transient suppression cable to the 1x5M<br />
header at P3 on the controller.<br />
4 Mount the 2210MX to the display case.<br />
5 Connect the 1x5F connector on the touchscreen cable to the<br />
1x5M connector on the transient suppression cable.<br />
6 Connect the ground wire of the transient suppression cable to an appropriate<br />
ground inside the display.<br />
7 Pull any excess cabling back into the display case.<br />
8 Reattach the case to the monitor.<br />
Complete the following steps if you are using a wall mount power supply:<br />
1 Two different wall mount power supplies are available. Use P/N 580979-000<br />
if you are using this inside the United States and P/N 319865-000 if you are<br />
using this outside of the United States.<br />
2 Plug the single male connector on one end of the power supply into the<br />
connector on the serial cable.<br />
3 Plug the other end of the power supply into a proper receptacle.<br />
4 Plug the DB9F end of the attached serial cable into a serial port.<br />
5 Proceed to “Where to Go from Here” on page 3-30.<br />
4-53