Smart Infrared Inspection System Field Operational Test - Center for ...

38
International Electronic
Machines Corporation
SYSTEM
DESCRIPTION
GENERAL
DESCRIPTION
This photo shows the typical configuration of the SIRIS
The Smart InfraRed
system. The components, which are detailed below, are: 1.
Inspection System (SIRIS)
Main unit, 2. Ultrasonic Detector, 3. Infrared Camera (a
is a tool designed to assist
second infrared camera is located on the other side of the
inspectors in determining
vehicle and is not shown), 4. Optical Trigger (the other half
which vehicles passing
of the optical trigger system is located on the other side of
through the system are in
the vehicle and is not shown), and 5. Vehicle Camera. Not
need of further inspection
by measuring the thermal data from the wheel components. SIRIS is setup as a permanent
installation in a configuration similar to the photo above though your system could vary.
IEM engineers will work with inspection personnel to find the best placement for the
system. This system is an advisory system and does not replace the inspection process.
COMPONENT DESCRIPTION
Main Unit
Ultrasonic Detector
The Main Unit is a rugged case that holds the operating
computer for the system components. This computer is linked
to User Interface computer housed in the scale house or other
protected structure. The User Interface computer collects data,
issues alerts and displays the User Interface.
The ultrasonic detector is triggered when a vehicle enters the
system. This activates the system to capture thermal data.