Smart Infrared Inspection System Field Operational Test - Center for ...

SYSTEM START UP
GETTING STARTED
The SIRIS system is designed to run continuously. The following instructions should
be followed when all of the components are powered on. If the components are not
powered on, see the troubleshooting section of this manual.
Open the SIRIS program on the user interface computer, which is located in the
inspection facility or other enclosure, by clicking on the SIRIS icon on the desktop.
Once the program has started, connect to the Main Unit by clicking on the
“Connecting” button. The Module Status will change to Connected.
A new session is started when the system is connected. A session is considered all of
the collected vehicle data for a selected period. A session is used to identify the folder
in which to look for collected data. More information on Sessions can be found in the
User Interface Basics section.
In order to start collecting, click the “Start Collecting” button. The system will start
collecting data from passing vehicles and the Module Status (see the User Interface
Basics section for more information on Module Status) will state Starting and then
Collecting.
The system is now operating and collecting data. This data is saved on the computer
in easily accessed files. See the User Interface Basics section for more information.
44