G3 Series PROFIBUS-DP Technical Manual - ASCO Numatics
G3 Series PROFIBUS-DP Technical Manual - ASCO Numatics
G3 Series PROFIBUS-DP Technical Manual - ASCO Numatics
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Sub-Bus In Modules<br />
<strong>G3</strong> <strong>Series</strong> <strong>PROFIBUS</strong>‐<strong>DP</strong> <strong>Technical</strong><br />
<strong>Manual</strong><br />
Used to distribute I/O assemblies that do not have valves<br />
o Must be installed to the right of the I/O modules.<br />
Sub-Bus In - 5 pin M12 male communication connector.<br />
o Must be connected to the Sub-Bus Out connector of the previous assembly<br />
o Carries 24 VDC power for electronics of module<br />
Aux. Power In - 4 pin M12 male connector.<br />
o Aux power is required for Output modules. This connection also allows Output power to be<br />
interrupted to all Output modules connected to this module.<br />
o Aux. Power is optional for Inputs. Power from the Sub-Bus In connection is used to power<br />
sensors but can be augmented, if necessary, by adding additional power to this connector.<br />
Description Part Number<br />
Sub-Bus In module with Din Rail Mounting 240-246<br />
Sub-Bus In module without Din Rail Mounting 240-185<br />
TD<strong>G3</strong>PTTM1-2EN 02/09<br />
Subject to change without notice<br />
www.numatics.com/g3<br />
Page 31
Change language