ER-200D Personal Noise Dosimeter with Data Logging User Manual

Data Table
All data runs are displayed in the Data Table, with the most
recent run at the top of the list.
· Serial Number: Device serial number
· Run: Sequential, beginning with 001
· Run Type:
Normal or QuickCheck
· Final Dose %: Dose at end of run
· Overall Leq: A-weighted continuous equivalent sound level
· Run Description: This is a textbox in which the user can enter data
describing the run
ExAMPLE:
“Jane Smith, Packing Line 1, Full Capacity, First Shift, 5-18-2009.”
To Enter A Run Description
· Double-click on the desired run or click the blue “Describe Run”
box on the screen.
· Type information into dialogue box and click OK.
· Run description will be immediately updated.
Note: Once a report is created, the Run Description cannot be
altered in the report. A new report can be made, but it must be
saved using a different file name.
· Run Length: Actual run time, displayed as
Days-Hours-Minutes-Seconds
· Max Run Length: Maximum time the dosimeter could run
· Exchange Rate, Criterion and Threshold:
As selected from the Setup Screen
· Signal Source: internal microphone (default) or direct input
· Calibration: Calibration value used at the time of the run
· Run Termination: Completed normally; manual
shutdown; or sudden power loss
· Warnings: Any warnings that occurred during the run
· Software Version: software version at the time
of the run
47