14.10.2013 Views

001-055 Alfa 156 GB - Alfa Romeo serviss

001-055 Alfa 156 GB - Alfa Romeo serviss

001-055 Alfa 156 GB - Alfa Romeo serviss

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Warning light<br />

on the dial<br />

t<br />

t<br />

Message<br />

on display<br />

SELESPEED GEARBOX FAILURE<br />

Turning the ignition key to MAR, the warning light on the cluster shall come on and then go off after<br />

about 4 seconds. If the warning light stays on, it indicates that a fault has been detected in the Selespeed<br />

gearbox; at the same time, the buzzer beeps intermittently for 4 seconds to draw the attention<br />

of the driver. Contact <strong>Alfa</strong> <strong>Romeo</strong> Authorised Services as soon as possible to remove the fault.<br />

Q-SYSTEM AUTOMATIC GEARBOX FAILURE<br />

Turning the ignition key to MAR, the warning light on the cluster shall come on and then go off<br />

after about 4 seconds. If the warning light stays on or turns on when travelling, it indicates overheated<br />

gearbox oil (glowing steadily) or a gearbox fault (flashing).<br />

Warning light glowing steadily: it indicates that the gearbox oil has reached the maximum<br />

established temperature.<br />

To make oil cooling down, stop the car, move the lever to P or N and let the engine idle until the<br />

warning light goes out. Resume driving without demanding high performance from the engine. If<br />

the warning light comes on again, it is necessary to stop again with the engine idling until it goes<br />

out again. If the interval between one lighting up of the warning light and next is below 15 minutes,<br />

you are advised to stop the car, turn the engine off and wait for the engine-gearbox unit to cool down<br />

completely. Contact <strong>Alfa</strong> <strong>Romeo</strong> Authorised Services as soon as possible.<br />

Warning light flashing: it indicates a fault in the automatic gearbox.<br />

The automatic control system provides an emergency programme. Under these circumstances,<br />

you are advised to stop the car and turn the engine off; in fact, the next time the engine is started,<br />

the self-diagnostic system could cut off the fault which will however be memorised. Conversely, if<br />

the fault remains (warning light flashing), it is necessary to select the gears manually as if driving<br />

a car with mechanical gearbox, bearing in mind that the only two speeds available are the 2nd and<br />

4th gear. Contact <strong>Alfa</strong> <strong>Romeo</strong> Authorised Services as soon as possible.<br />

GETTING TO KNOW YOUR CAR<br />

107

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!