001-055 Alfa 156 GB - Alfa Romeo serviss

IN AN EMERGENCY
222
The Xenon lamp must be
handled touching only the
metallic part. If the transparent
bulb is touched with the fingers,
rub it with a clean cloth
moistened with methylated spirits
and allow to dry before refitting
the bulb.
WARNING Once the operation has been
completed, turn dipped beam headlamps on
and check that the headlight parabola
moves when positioning the light itself. If
not, re-engage the lamp.
– Turn ring (A-fig. 26) counter-clockwise
and remove it.
– Remove the Xenon lamp (B-fig. 26).
– Fit the new bulb by placing it so that the
notch matches the groove on its housing.
– Refit the protective cover correctly
(A-fig. 23).
fig. 26
A0B0352m
Main beam headlamps
To replace the bulb proceed as follows:
– Turn the protective cover counter-clockwise
(C-fig. 23) in order to reach the highbeam
headlight bulb (A-fig. 24).
– Remove connector (A-fig. 27) and remove
the bulb operating the clips (B) as
shown in the figure.
– Fit the new bulb.
– Refit the protective cover correctly (Cfig.
23).
fig. 27
A0B0350m