Expansion modules - Automatech

Products
Expansion modules
PNOZ mc5p
Function description
The data to be transferred via INTER-
BUS is selected and configured in the
PNOZmulti Configurator. The base
unit and the PNOZ mc5p are connected
via a jumper. The PNOZ mc5p is
also supplied with voltage via this
jumper. After the supply voltage is
switched on or the PNOZmulti safety
system is reset, the PNOZ mc5p is
configured and started automatically.
Wiring
2.3
The wiring is defined in the circuit diagram
of the PNOZmulti Configurator.
It is possible to define which outputs
on the safety system will communicate
with INTERBUS. The connection to IN-
TERBUS is made via two female 9-pin
D-Sub screw connectors
9
6
6
9
5
1
1
5
1: DO2
2: DI2
3: GND
4: n.c.
5: GND
6: /DO2
7: /DI2
8: n.c.
9: RBST
1: DO1
2: DI1
3: GND
4: n.c.
5: n.c.
6: /DO1
7: /DI1
8: n.c.
9: n.c.
n. c. = not connected
Please note:
Information given in the “Technical
details” must be followed.
Use copper wire that can withstand
75 °C.
Please note the following when connecting
to INTERBUS:
Only use metal plugs or metallised
plastic plugs
Twisted pair, screened cable must
be used to connect the interfaces
2.3-90
Pilz GmbH & Co. KG, Sichere Automation, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: pilz.gmbh@pilz.de
NSG-D-2-375-2006-02