Expansion modules - Automatech

Products
Expansion modules
PNOZ mc7p
Function description
The data to be transferred via CC-Link
is selected and configured in the
PNOZmulti Configurator. The base
unit and the PNOZ mc7p are connected
via a jumper. The PNOZ mc7p is
also supplied with voltage via this
jumper. The station address is set via
2 rotary switches. After the supply
voltage is switched on or the PNOZmulti
safety system is reset, the PNOZ
mc7p is configured and started automatically.
Wiring
2.3
The wiring is defined in the circuit diagram
of the PNOZmulti Configurator.
It is possible to define which outputs
on the safety system will communicate
with CC-Link. The connection to CC-
Link is made via a 5-pin screw connector.
1 2 3 4 5
DA
DB DG SLD FG/
PE
DA
DB
DG
SLD
FG/PE
1: DA (Channel A)
2: DB (Channel B)
3: DG (Earth)
4: SLD (Cable shield)
5: FG/PE (Functional earth)
Please note:
Information given in the “Technical
details” must be followed.
Use copper wire that can withstand
75 °C.
Please note the following when connecting
to CC-Link:
Only use metal plugs or metallised
plastic plugs
Twisted pair, screened cable must
be used to connect the interfaces
2.3-106
Pilz GmbH & Co. KG, Sichere Automation, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: pilz.gmbh@pilz.de
NSG-D-2-378-2006-02