Palm-I Unit Model 969-9892 - Agilent Technologies
Palm-I Unit Model 969-9892 - Agilent Technologies
Palm-I Unit Model 969-9892 - Agilent Technologies
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
18<br />
Technical Information<br />
Use<br />
• XXX set the vent valve managing output (OFF/ON).<br />
Pressing the TEMPERATURE push button will display:<br />
V E N T V A L V E<br />
O P E R A T I O N : X X X X<br />
where:<br />
• XXXX set the vent valve operation output (auto/man.).<br />
Pressing the TEMPERATURE push button will display:<br />
V E N T V A L V E D E L A Y<br />
where:<br />
X X X X s e c<br />
• XXXX set (from 0000 to 9999 seconds) the vent valve delay.<br />
Pressing four times the TEMPERATURE button will exit from<br />
configuration mode.<br />
Control the Pump<br />
If the forepump and vent device are not operated by the controller,<br />
close the vent valve and switch on the forepump.<br />
• Press the START push-button or use the remote or RS 232 start<br />
signal, the display shows:<br />
P U M P S T A R T I N G<br />
• After START command, frequency output will be at the maximum<br />
level, then the frequency will decrease to a value proportional to<br />
the pump rotational speed (1/4 of nominal frequency if the pump<br />
is completely stopped).<br />
The pump will accelerate to its normal rotational speed and when<br />
this speed is reached, the display will be as follows, even if any<br />
previous display selection was made, and the normal condition has<br />
been reached.<br />
124/138 PALM-I UNIT User Manual / 87-900-950-01 (E)