Part - Studio Lights

LX 1.0 / LX 1.5 / LX 2.2
stage-sound
POWER AMPLIFIER
LED indicators
Protect LED
lit, when power is switched on or when a fault
occurs.
Clip/Lim LED
lit in the event of signal overload
Signal LED
lit from an amplification of 100 mV
Power LED
indicates the operating status of the amplifier
● FRONT VIEW
Limiter switch
Switch for activating the limiter
Volume controls
For adjusting the volume of the respective channel
Power switch
Switch for turning the device on/off.
IEC power inlet (cold condition)
Connection for power cord
● REAR VIEW
Signal input and LINK
Balanced inputs on XLR sockets and LINK outputs
on balanced jack sockets (6.3 mm).
LS outputs
Speaker sockets or 2-pin screw-type sockets
for connection of loudspeakers
Ground/Lift
Switch for disconnecting signal ground from
chassis ground (shielding), in order to avoid
any hum pick-up.
Mode switch
Switch to select the operating mode: stereo or
bridged
Technical data LX 1.0 LX 1.5 LX 2.2
Output power (1 kHz, 1 % THD) 8 ohms stereo 2 x 170 W 2 x 255 W 2 x 355 W
4 ohms stereo 2 x 255 W 2 x 370 W 2 x 370 W
8 ohms bridged 1 x 510 W 1 x 740 W 1 x 1100 W
Output power (1 kHz, 0.1 % THD) 8 ohms stereo 2 x 160 W 2 x 240 W 2 x 345 W
4 ohms stereo 2 x 235 W 2 x 355 W 2 x 530 W
Frequency response
20 - 20,000 Hz +0 / -0.5 dB
Input sensitivity at 4 ohms
+4 dBu/1.23 V
Signal-to-noise ratio
better than 100 dB
Crosstalk
better than 65 dB
Input clipping
10 Vrms (+22 dB)
Damping factor (8 ohms, 1 kHz) better than 300
Slew rate
better than 50 V/us
Power supply
220V – 240V/AC, 50~60 Hz
Power consumption at 4 ohms 880 W 1135 W 1860 W
Dimensions (W x H x D)
483 x 88 x 380 mm, (2 RU)
Weight 12 kg 12.3 kg 14.5 kg
208