Part - Studio Lights

6-CHANNEL POWER AMPLIFIER (100 V, 70 V, 50 V)
BA-6060 P6
360 W
6 x 60 W
According to VDE 0828 (DIN EN 60849) from IEC 268-3
BA-6120 P6
720 W
6 x 120 W
Description
These fully monitored 6-channel 19˝-Power Amplifier
according to IEC 268-3 are perfectly suitable for application
in professional 100 V devices with 100 V, 70 V, 50 V or 4 Ohm
technology.
The amplifier has 6 individually separated, very low leaking
power supplies with a ring core transformer. They are
produced according to the latest assembly methods with
high-quality components.
These Power Amplifiers are absolutely short circuit and
engine idling proof with all relevant safety arrangements.
They are therefore especially appropriate for continuous
operation.
Please consider the following features:
● Each device of this „P6“-series has more than six
electronic symmetrical audio inputs. 6 NF-input
transformers can optionally be soldered as a refit under
ex-works conditions. (i.e. TSE-101)
● Six special circuits suppress any unwanted switch on
noises. Additionally all models are equipped with a
„SOFT-START“ (net switch on limitation).
● A ground/lift switch used to separate the connection of
frame ground / signal ground (screening) helps to avoid
hum loops.
● Each of the built-in Power Amplifiers has a 24V DC
voltage supply unit clamp for emergency power usage.
● Heat flow is carried out via two ball pivoted thermally
controlled DC-ventilator with minimum running noise and
high service life.
● Optional available:
High quality 1:1 NF input transmitter can be soldered
under ex-works conditions. For input 1 – 6 a TSE-101
can be ordered.
*
● The electronic symmetrical inputs are designed for
phoenix screw-type connectors. Due to balancing per
input (refit TSE-101 is ungrounded) buzzing interspersion
via ground loops is avoided.
● The input signals may be separately regulated via six
gauge controls, which are attached on the rear panel.
● 6 LED-VU meters are attached on the front panel of the
device give continuous information about the modulation
state of the individual Amplifiers. Additionally installed
LED-indicators provide a signal on the maybe appearing
state of integrated protective functions.
Model designations
6-Channel Power Amplifier, . . . . . . . . . . . . . . . . . . . BA-6060 P6
6 x 60 W RMS, (4 RU)
6-Channel Power Amplifier, . . . . . . . . . . . . . . . . . . . BA-6120 P6
6 x 120 W RMS, (4 RU)
Transformer-balanced input. . . . . . . . . . . . . . . . . . . . . . . TSE-101
35