Print Station Operator's Guide - Kodak
Print Station Operator's Guide - Kodak
Print Station Operator's Guide - Kodak
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Chapter 2. Operator Controls<br />
Service Menu Screen<br />
Figure 2.5<br />
Service menu<br />
** SERVICE MENU **<br />
Function Selections<br />
1 Ready - steps<br />
2 Clean - service<br />
3 Shut down<br />
4 Vacuum/ink fill<br />
5 All off<br />
6 Clean - install<br />
7 Sequence summary<br />
8 Control menu<br />
9 Parameters menu<br />
Choose a function, enter the number<br />
Press F1/F2 key for HELP.<br />
After a function is selected, a menu or screen associated with the<br />
selected item is displayed. Refer to Table 2.2 for detailed function<br />
information and uses. All functions can be accessed at any time.<br />
Table 2.2<br />
Item<br />
Service menu function<br />
Description<br />
1 Ready - steps Brings the printhead to Ready under direct operator<br />
control. The print station progresses through states<br />
1-12. However, to progress to states 13, 14, and 15,<br />
the operator must press the SPACEBAR to advance<br />
to ready. Typically used to looks at jets when trying to<br />
determine print quality issues. Selecting this function<br />
displays the STEP TO READY status screen. NOTE1<br />
2 Clean - service Starts a 3-minute printhead clean cycle with sonic<br />
stimulation. Typically, this function is used to clear<br />
print defects such as streakers, crooked jets, or<br />
charge shorts. Refer to Chapter 4, “Messages” for<br />
symptoms of print problems. Selecting this function<br />
displays the SERVICE CLEAN status screen.<br />
3 Shut down Shuts down the printhead. Typically used at the end<br />
of the day or prior to changing the printhead or ink in<br />
use. Selecting this function displays the<br />
SHUTDOWN PRINTHEAD status screen.<br />
4 Vacuum/ink fill Used to fill the print station ink tank. Selecting this<br />
item displays the VACUUM/INK FILL status screen.<br />
5 All off Turns off all pumps and servos immediately.<br />
Selecting this item displays the VACUUM/INK FILL<br />
status screen.<br />
6 Clean - install Starts a 10-minute printhead clean cycle with sonic<br />
stimulation. Typically, this function is used to clean a<br />
newly installed printhead. It can also be used to<br />
clean the printhead after the print station has been<br />
shut down for several days. Selecting this item<br />
displays the CLEAN - INSTALL status screen.<br />
Operator’s <strong>Guide</strong> 2 - 5
Change language