Instruction manual, SPT and MPT 31x series transponders

Batteries
1 Grab the connector firmly using both hands. Press the
connector onto the battery plug.
Figure 20 Connecting the battery
2 When the battery is connected, listen for the transponder
initialization:
Three bursts should be transmitted at a rate of one per
second.
-If no bursts are heard, disconnect the battery
immediately, and wait minimum 20 sec. before
connecting / reconnecting it again.
3 When the battery is correctly connected, assemble the
transponder.
Refer to page 78 for details.
4 Check that the unit is correctly assembled and sealed.
5 Perform a functional check before deployment.
Refer to page 41 for details.
160820/O 61