Instruction manual, SPT and MPT 31x series transponders
Instruction manual, SPT and MPT 31x series transponders
Instruction manual, SPT and MPT 31x series transponders
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>SPT</strong> <strong>and</strong> <strong>MPT</strong> <strong>31x</strong> <strong>series</strong><br />
7 TRANSPONDER CONFIGURATION<br />
This section holds information about the configuration of a<br />
transponder. All <strong>transponders</strong> are configured by the<br />
manufacturer. The configuration may be altered if required. The<br />
procedure to perform alterations will depend on the HiPAP /<br />
HPR system in use.<br />
A transponder can operate with the following topside systems:<br />
HiPAP<br />
HPR 400 <strong>series</strong><br />
HPR 300 <strong>series</strong><br />
Each transponder <strong>series</strong> is dedicated to a specific frequency<br />
b<strong>and</strong>.<br />
Altering the configuration, switching between the operating<br />
systems or changing the channel settings is done by:<br />
Acoustic telemetry.<br />
(A HiPAP or a HPR 400 system is required).<br />
Use of internal switches.<br />
(Located on the microcontroller board).<br />
A large number of transponder channels are available<br />
(depending on the selected system) to prevent interference<br />
between <strong>transponders</strong>, if several are located in the same area<br />
(a channel being an interrogation <strong>and</strong> reply frequency<br />
combination).<br />
Topics<br />
Frequency b<strong>and</strong> on page 64<br />
Acoustic telemetry -basics on page 65<br />
Switch settings - basics on page 65<br />
HPR 400/HiPAP channels on page 66<br />
HPR 300 channels on page 67<br />
Frequency b<strong>and</strong><br />
For the <strong>transponders</strong> described in this <strong>manual</strong>, the 30 kHz<br />
frequency b<strong>and</strong> is used.<br />
64 160820/O
Change language