640-802 CCNA Study Guide - Elktech.org

Requirement 1:
Name of the router is NEW_RTR
Cisco 640-802 Exam
Step2:
To change the hostname of the router to NEW_RTR follow the below steps
Router>
Router>enable
Router# configure terminal
Router (config)# hostname NEW_RTR
NEW_RTR(config)#
Requirement 2:
Enable-secret password is cisco
Step3:
To set the enable secret password to cisco use the following command
NEW_RTR(config)#enable secret cisco
Requirement 3:
The password to access user EXEC mode using the console is class
Step 4:
We need to configure the line console 0 with the password class
Also remember to type login command after setting up the password on line con 0 which allows
router to accept logins via
console.
NEW_RTR(config)# line con 0
NEW_RTR(config-line)#password class
NEW_RTR(config-line)#login
NEW_RTR(config-line)# exit
NEW_RTR(config)#
Requirement 4:
The password to allow telnet access to the router is class
Step 5:
To allow telnet access we need to configure the vty lines 0 4 with the password class
Also remember to type login command after setting up the password on line vty 0 4 which allows
router to accept logins via
telnet.
NEW_RTR(config)# line vty 0 4
NEW_RTR(config-line)#password class
"Pass Any Exam. Any Time." - www.actualtests.com 255