640-802 CCNA Study Guide - Elktech.org

QUESTION NO: 557
Cisco 640-802 Exam
Which commands are required to properly configure a router to run OSPF and to add network
192.168.16.0/24 to OSPF area 0? (Choose two.)
A. Router(config)# router ospf 1
B. Router(config)#router ospf 0
C. Router(config)#router ospf area 0
D. Router(config-router)# network 192.168.16.0 0.0.0.255 area 0
E. Router(config-router)#network 192.168.16.0 0.0.0.255 0
F. Router(config-router)#network 192.168.16.0 255.255.255.0 area 0
Answer: A,D
Explanation:
QUESTION NO: 558
Given an IP address 172.16.28.252 with a subnet mask of 255.255.240.0, what is the correct
network address?
A. 172.16.16.0
B. 172.16.24.0
C. 172.16.0.0
D. 172.16.28.0
Answer: A
Explanation:
QUESTION NO: 559
Which command can be used to verify the DLCI destination address in a Frame Relay static
configuration?
A. show frame-relay end-to-end
B. show frame-relay map
C. show frame-relay lmi
D. show frame-relay pvc
Answer: B
Explanation:
"Pass Any Exam. Any Time." - www.actualtests.com 388