640-802 CCNA Study Guide - Elktech.org

QUESTION NO: 382
Cisco 640-802 Exam
You just entered the following command_Router(config#) lineconsole 0 Which operation is most
likely to follow?
A. Configure the terminal type.
B. Enter protocol parameters for a serial line.
C. Create a password on the console terminal line.
D. Establish a terminal type 4 connection to a remote host.
Answer: C
Explanation:
A console password is configured from global configuration mode, at the console line level. The
output below outlines each step from privileged EXEC mode forward.
Company-1#config tEnter configuration commands, one per line. End with CNTL/Z.Company -
1(config)#line console 0Company -1(config-line)#loginCompany -1(config-line)#password cisco1
QUESTION NO: 383
The Company WAN is migrating from RIPv1 to RIPv2. Which three statements are correct about
RIP version 2? (Choose three)
A. It has the same maximum hop count as version 1.
B. It uses broadcasts for its routing updates.
C. It is a classless routing protocol.
D. It has a lower default administrative distance than RIP version 1.
E. It supports authentication.
F. It does not send the subnet mask in updates.
Answer: A,C,E
Explanation:
RIPV1
RIPV1 is a classful routing protocol , it sends update packets which does not contain subnet mask
information every 30 seconds , it does not support VLSM and performs border automatic route
summary by default, it can't be shut down, so it does not support non-consecutive networks and
authentication, it uses hop counts as metric, the administrative distance is 120. Each packet
contains 25 routing information at most , and routing update is broadcast.
RIPV2
"Pass Any Exam. Any Time." - www.actualtests.com 281