640-802 CCNA Study Guide - Elktech.org

Cisco 640-802 Exam
QUESTION NO: 592
Which of the following are true regarding the debug output shown in the graphic? (Choose two)
A. This router was configured with the commands:
RtrA(config)#router rip
RtrA(config-router)#version 2
RtrA(config-router)#network 172.16.0.0
RtrA(config-router)#network 10.0.0.0
B. This router was configured with the commands:
RtrA(config)#router rip
RtrA(config-router)#network 172.16.0.0
RtrA(config-router)#network 10.0.0.0
C. Network 10.0.0.0 will be displayed in the routing table.
D. Network 192.168.168.0 will be displayed in the routing table.
E. This router was configured with the commands:
RtrA(config)#router rip
RtrA(config-router)#network 192.168.1.0
RtrA(config-router)#network 10.0.0.0
RtrA(config-router)#network 192.168.168.0
F. split-horizon was disabled on this router.
Answer: B,C
Explanation:
Routing Information Protocol (rip) is a distance vector protocol that uses hop as a metric. Rip
routing metriC. rip uses single routing metric (hops) to measure the distance from source network
to destination network. From source to destination, every hop is given a value, which is usually 1.
When routers receive route update information of new or changed destination network, the metric
value will be added 1 and then stored into a routing table, the ip address of the sender will be used
"Pass Any Exam. Any Time." - www.actualtests.com 404