Consultation Draft - National Transport Commission

Model Amendment Regulations – Transport of Dangerous Goods by Road or Rail –
Package No. 2
location so as to be readily visible when the inner receptacle is
placed in the outer casing.
The date of the manufacture of the plastics inner receptacle may
alternatively be marked on the inner receptacle adjacent to the
remainder of the marking. An example of an appropriate marking
method is:
6.5.2.4 Add a new paragraph 6.5.2.4 to read as follows:
".
"6.5.2.4 Marking of remanufactured composite IBCs
(31HZ1)
The marking specified in 6.5.2.1.1 and 6.5.2.2 must be removed
from the original IBC or made permanently illegible and new
markings must be applied to an IBC remanufactured in accordance
with this Code.".
6.5.4.1 At the beginning, insert ", remanufactured, repaired" after
"manufactured". At the end, insert ", remanufactured or repaired"
after "manufactured".
6.5.6.2.1 Replace "6.5.6.5" with "6.5.6.4".
6.5.6.9.5 (d) At the end, add the following new note:
"NOTE: The criteria in (d) apply to design types for IBCs
manufactured as from 1 July 2015.".
Chapter 6.6
6.6.1.2 Replace "and tested" with ", tested and remanufactured" and, at the
end, insert "or remanufactured large" after "each manufactured".
6.6.3.1 In the first paragraph, replace "durable and legible markings
showing:" with "markings which are durable, legible and placed in a
CONSULTATION DRAFT
139