Consultation Draft - National Transport Commission

More documents

Recommendations

Info

(g) any other information necessary to enable an assessment of whether the device complies with 6.11.7.2. 6.11.7.4 Approval number to be displayed 6.11.7.4.1 An approved underslung segregation device must be clearly and permanently marked, in a conspicuous position, in lettering not less than 25mm high with the following: (a) (b) where: for a device approved by a Competent Authority: Name of Competent Authority APPROVED SEGREGATION DEVICE FOR USE IN (State/Territory) ONLY APPROVAL XXX DESIGN LOAD YYY for a device approved by the Competent Authorities Panel: AUSTRALIAN COMPETENT AUTHORITIES APPROVED SEGREGATION DEVICE FOR USE IN AUSTRALIA ONLY CAP REFERENCE CA20--/---- DESIGN LOAD YYY XXX is the approval number issued by the Competent Authority YYY is the maximum weight, in kg, that the device may carry.". 13. Marking of overpacks After 5.1.2.1.2 insert – "5.1.2.1.3 Despite 5.1.2.1.1, if markings and labels representative of all dangerous goods in the overpack are not visible, and all of the dangerous goods are limited quantity items, the overpack may be marked with the limited quantity marking specified in Chapter 3.4.". 14. Omission of transitional provision concerning orientation arrows Omit 5.2.1.7.4 and the note immediately beneath 5.2.1.7.4. 15. Marking of inner packages (1) In 5.2.1.8, for "Except where labelled and marked" substitute "Unless marked". (2) In 5.2.1.8, in Table 5.1, in the columns relating to Class or Division 2.1 and 2.3, for "30 ml" substitute "50 ml". (3) In 5.2.1.8, in note a under Table 5.1, for "AS 2778" substitute "AS 2778.1". CONSULTATION DRAFT 20
(4) In 5.2.1.8, at the end of note c under Table 5.1 insert ", Division 6.2 Category B is not required to be marked". 16. Labelling provisions For the heading "5.2.2.1 Labelling provisions", the 2 notes immediately beneath that heading, and 5.2.2.1.1 substitute – "5.2.2.1 Labelling provisions NOTE: These provisions relate essentially to danger labels. However, additional markings or symbols indicating precautions to be taken in handling or storing a package (e.g. a symbol representing an umbrella indicating that a package must be kept dry) may be displayed on a package if appropriate. 5.2.2.1.1 All dangerous goods packages, cylinders, pressure drums, tubes, MEGCs, IBCs, overpacks and unpackaged articles that are subject to this Code must have a label that identifies the primary and subsidiary risks of the dangerous goods and that conforms to models Nos. 1 to 9 illustrated in 5.2.2.2.2, except: (a) (b) (c) (d) (e) those IBCs, pressure drums, tubes, MEGCs and articles which are placardable units that are placarded with emergency information panels in accordance with Chapter 5.3; or where there is an exemption from labelling in an applicable Special Provision in Chapter 3.3; or for dangerous goods in limited quantities that are packed and marked in accordance with Chapter 3.4; or where permitted in Chapter 7.3 for retail distribution loads; or where there is existing marking equivalent to the label that complies with GHS. For the purposes of this provision, the “EXPLOSIVE” subsidiary risk label is model No. 1. NOTE 1 Unlike earlier editions, in this Code a label identifying a subsidiary risk is now identical to the Class or Division label used for the same hazard, as illustrated in 5.2.2.2.2. The appropriate Class or Division number indicating the subsidiary risk must be displayed in the bottom corner of the label. NOTE 2 For paragraph (e), see 1.2.3.3.1 for how references to GHS are to be interpreted.". 17. Change to GHS references (1) In 5.2.1.8, after "Table 5.1 following:" insert – "NOTE: See 1.2.3.3.1 for how references to GHS are to be interpreted.". (2) In 5.2.2.1.13.1 – (a) omit "labelled and"; (b) after "in the table at 5.2.1.8." insert – "NOTE: See 1.2.3.3.1 for how references to GHS are to be interpreted.". CONSULTATION DRAFT 21
Page 1 and 2: Consultation Draft Model Amendment
Page 3 and 4: Model Amendment Regulations -Transp
Page 5 and 6: Schedule 1 - Amendments to the Mode
Page 7 and 8: (b) (c) (a) (b) (c) (d) (e) (f) a r
Page 9 and 10: "(4) {Subclause} (3) does not apply
Page 11 and 12: (2) The prime contractor must retai
Page 13 and 14: (2) The Competent Authority must ha
Page 15 and 16: 4. Goods too dangerous to be transp
Page 17 and 18: G These entries must be used for cy
Page 19: "(d) a Non-Type I Underslung Segreg
Page 23 and 24: 1 IBC with ½ size EIP fully visibl
Page 25 and 26: "10.2.3.7 Despite 10.2.3.1 and 10.2
Page 27 and 28: Note 2: In cases of combination veh
Page 29 and 30: UN HAZCHEM HIN UN HAZCHEM HIN UN HA
Page 35 and 36: UN HAZCHEM HIN 3272 3YE (3) 33 3Y 3
Page 37 and 38: Model Amendment Regulations - Trans
Page 71 and 72:
Model Amendment Regulations - Trans
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Not less than 250 mm Model Amendmen
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Page 159:
show all

Consultation Draft - National Transport Commission

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?