Consultation Draft - National Transport Commission

More documents

Recommendations

Info

"(a) AS/NZS 1841.1, AS/NZS 1850 and AS1851; and". (2) In 12.1.2.3(b), for "5, 6 or 7" substitute "or 5". (3) In 12.1.2.5.4, for "Where" substitute ""Except in the case of a combination vehicle, if". (4) For 12.1.2.5.4(b) substitute – "(b) in the cabin for all other vehicles.". (5) After 12.1.2.5.4 insert – "12.1.2.5.5 If 12.1.2.5.4 or Table 12.1 requires that a fire extinguisher be located in the cabin, as an alternative to being located in the cabin the fire extinguisher may be located directly behind the cabin or may be mounted on the rear of the cabin.". (6) For Table 12.1 substitute – "Table 12.1 Minimum Fire Extinguisher Requirements for Road Vehicles <strong>Transport</strong>ing a Placard Load of Dangerous Goods Load: All types of dangerous goods packed in: • packages, drums, overpacks, segregation devices • intermediate bulk containers (IBCs) containing non-flammables – any quantity • IBCs containing flammables with up to (and including) 10,000 L total capacity or containing up to (and including) 10,000 kg. in total Required extinguishers: 1 x 30B dry powder that is to be placed in the cabin (see 12.1.2.5.5), or at the front of any trailer transporting a placard load Load: Non-flammable goods packed in: pressure drums, tubes, multiple element gas containers (MEGCs), tanks, bulk containers (solids) Required extinguishers: 1 x 60B dry powder, or 2 x 30B dry powder, in the load area 1 x 10B dry powder in the cabin (see 12.1.2.5.5) Load: Flammable goods packed in: • pressure drums, tubes, MEGCs, tanks, bulk containers (solids) • IBCs > 10,000 L total capacity or containing >10,000 kg. in total Required extinguishers: 2 × 60B dry powder, or 1x 80B dry powder and 1 x 20B foam, in the load area 1 x 10B dry powder in the cabin (see 12.1.2.5.5) Note 1: In this table "flammable goods" means dangerous goods of Division 2.1, Class 3 or Class 4, or having a subsidiary risk of 2.1, 3 or 4. CONSULTATION DRAFT 26
Note 2: In cases of combination vehicles, these directions apply to every separate trailer transporting a placard load.". 42. Where a vehicle may be parked (1) In 13.1.3.2.2.2(a)(iv), after "any law" insert ", other than a law regulating driver fatigue". (2) After 13.1.3.2.2.3 insert – "13.1.3.2.2.4 13.1.3.2.2.1(d) does not apply to a road vehicle transporting dangerous goods that is parked or left standing in an area to which there is no public access. 13.1.3.2.2.5 Despite 13.1.3.2.2.1, a vehicle carrying BATTERIES, WET, FILLED WITH ACID, electric storage (UN 2794) of Packing Group III that each have a gross mass of 65kg or less, and that together have a gross mass of 5000kg or less, may: (a) (b) park in a public place if: (i) (ii) in the case of an enclosed vehicle, the load area is locked; or in the case of a tray-sided vehicle, the load is covered, or the vehicle is supervised; and be garaged in a residential area if: (i) (ii) in the case of an enclosed vehicle, the load area is locked; or in the case of a tray-sided vehicle, the garage is locked. 13.1.3.2.2.6 However, 13.1.3.2.2.5 only applies if the transport documentation for the load states the number of batteries in the load, and if that number is adjusted after each delivery so that it accurately states the number of batteries in the load at all times.". 43. Emergency action codes (1) In Appendix C, in the section dealing with Emergency Action Codes – (a) in C2.3.3, after paragraph (f) insert – "However, full fire kit need not be worn if so determined by an incident controller, after assessing the relevant risks."; (b) at the end of C2.7.1 for all words and expressions after "unless" insert – "(a) the EACs for all the dangerous goods in the load include a bullet; or (b) in the case of a bullet indicating polar chemicals, none of the dangerous goods in the load has a bullet in its EAC.". (2) In Appendix C, for C3 (the List of Emergency Action Codes) substitute – CONSULTATION DRAFT 27
Page 1 and 2: Consultation Draft Model Amendment
Page 3 and 4: Model Amendment Regulations -Transp
Page 5 and 6: Schedule 1 - Amendments to the Mode
Page 7 and 8: (b) (c) (a) (b) (c) (d) (e) (f) a r
Page 9 and 10: "(4) {Subclause} (3) does not apply
Page 11 and 12: (2) The prime contractor must retai
Page 13 and 14: (2) The Competent Authority must ha
Page 15 and 16: 4. Goods too dangerous to be transp
Page 17 and 18: G These entries must be used for cy
Page 19 and 20: "(d) a Non-Type I Underslung Segreg
Page 21 and 22: (4) In 5.2.1.8, at the end of note
Page 23 and 24: 1 IBC with ½ size EIP fully visibl
Page 25: "10.2.3.7 Despite 10.2.3.1 and 10.2
Page 29 and 30: UN HAZCHEM HIN UN HAZCHEM HIN UN HA
Page 35 and 36: UN HAZCHEM HIN 3272 3YE (3) 33 3Y 3
Page 37 and 38: Model Amendment Regulations - Trans
Page 77 and 78:
Model Amendment Regulations - Trans
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Not less than 250 mm Model Amendmen
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Page 159:
show all

Consultation Draft - National Transport Commission

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?