Consultation Draft - National Transport Commission

Model Amendment Regulations – Transport of Dangerous Goods by Road or Rail –
Package No. 2
unintended opening through impact or other inadvertent act;
and".
6.7.2.8.4 At the end, add the following sentence: "In addition, fusible
elements conforming to 6.7.2.10.1 may also be used.".
6.7.2.10.1 In the first sentence, replace "110 °C" with "100 °C". In the second
sentence, replace "in no case must they" with "when used for
transport safety purposes, they must not". In the third sentence,
replace "utilized" with "used" and at the end of the sentence, add
"unless specified by special provision TP36 in Column 11 of the
Dangerous Goods List of Chapter 3.2.".
6.7.2.13.1 After sub-paragraph (e), add the following new sub-paragraph (f):
"(f) The cross sectional flow areas of the spring loaded
pressure-relief devices, frangible discs and fusible elements
in mm 2 .".
Renumber existing sub-paragraph (f) as sub-paragraph (g).
6.7.2.13.2, 6.7.3.9.2, 6.7.4.8.2 and 6.7.5.6.2
Replace "ISO 4126-1:1991" with "ISO 4126-1:2004 and ISO 4126-
7:2004".
6.7.2.20.1 Amend to read as follows:
"6.7.2.20.1 Every portable tank must be fitted with a corrosion
resistant metal plate permanently attached to the portable tank in a
conspicuous place readily accessible for inspection. When for
reasons of portable tank arrangements the plate cannot be
permanently attached to the shell, the shell must be marked with at
least the information required by the pressure vessel code. As a
minimum, at least the following information must be marked on the
plate by stamping or by any other similar method:
(a)
(b)
(c)
Owner information
(i) Owner’s registration number;
Manufacturing information
(i) Country of manufacture;
(ii) Year of manufacture;
(iii) Manufacturer’s name or mark;
(iv) Manufacturer’s serial number;
Approval information
142
CONSULTATION DRAFT