GRAIN DRYER & PARTS BOOK - Opico

8. LUBRICATION
Use a high-low temperature grease or equivalent made especially for ball and roller bearings in
extreme temperature.
Refer to the following chart for location of lubrication points and frequency of lubrication. A small
amount of grease at the specified intervals is recommended over a large amount at less frequent intervals.
*
*
* These points are located at centralized panel.
When performing the 100 hour lubrication, check to see that the set screws in bearing and tumblers are tight.
IMPORTANT:
In extremely cold weather, it may be necessary to operate the dryer empty for a short period
of time to allow the grease in the bearings to warm up.
12