Solenoid-Diaphragm Dosing Pump

Solenoid-Diaphragm Dosing Pump MAGDOS LP
Operating Instructions
5 Technical Data
5.1 Delivery capacity data
Please note that some of this data only represents guide values. The actual capacity of a dosing pump depends on various factors. For approximate
values of the delivery capacity at diffferent pressures, refer to „Delivery characteristic curves“ (see page 53).
Information
Value
MAGDOS LP size
05 1 2 4 6 10 15
Delivery capacity at max. backpressure
l/h 0.36 0.76 1.9 3.4 6.2 9.0 13
ml/stroke 0.05 0.05 0.2 0.31 0.57 0.83 0.86
max. back pressure bar 16 8 6 3
Max. delivery pressure in Eco-Mode 1* bar 10 6 4 2
Max. delivery pressure in Eco-Mode 2* bar 6 4 2 1
Delivery capacity at average backpressure
l/h 0.54 1.1 2.3 3.8 6.8 10 15
ml/stroke 0.08 0.07 0.24 0.35 0.63 0.92 1.0
Average back pressure bar 8 4 3 1
Max. stroke frequency RPM 120 250 160 180 250
Suction head for non-gassing media
(suction line filled)
mWS 5 3 2
Table 5-1: Output data
* In the case of operation in Eco-Mode energy saving mode, the delivery capacity is 5-10 % less than in normal mode (with the same backpressure).
If necessary, recalibration may be necessary (see „Calibrating the dosing pump“ on page 38).
5.2 Operating conditions and limits
Information
Value
MAGDOS LP size
05 – 15
Max. ambient temperature °C 45 (40 with PVC parts)
Relative humidity % Max. 90
Max. sound pressure level (depressurised) dB(A) 68 – 75
Max. sound pressure level (at test pressure)
dB(A) 65 – 70
Max. supply pressure mbar 800
Viscosity limits mPa s 300* / 1000**
Linear dosing range % 10 – 100
Table 5-2: Operating conditions and limits
* With a viscosity of ~300 mPa s and above, you must use spring-loaded valves.
** If the viscosity is above 1000 mPa s, this must be checked individually and the stroke frequency must be between 50 and 100 strokes/min.
© Lutz-Jesco GmbH 2012
Subject to technical changes.
BA-10231-02-V01
Technical Data
Delivery capacity data
11