YBA250 Antenna and Transmission Line Analyzer User Manual
YBA250 Antenna and Transmission Line Analyzer User Manual
YBA250 Antenna and Transmission Line Analyzer User Manual
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Appendix E: Functional Verification<br />
Procedure<br />
This appendix provides a functional verification procedure. The<br />
procedure verifies the basic functionality of the <strong>YBA250</strong>. The<br />
functional verification procedure can be used for incoming<br />
inspection purposes.<br />
NOTE. The functional verification procedure in this appendix does<br />
not confirm that the <strong>YBA250</strong> meets or exceeds the performance<br />
requirements for the specifications listed in Appendix A.<br />
There are two parts to this procedure:<br />
<br />
<br />
Self Tests: provides instructions for performing the internal<br />
diagnostic self-tests.<br />
Functional Tests: provides instructions for verifying<br />
capabilities not completely covered by the diagnostic<br />
self-tests. Requires the use of a signal generator.<br />
Self Tests<br />
Equipment Required<br />
None.<br />
Prerequisite<br />
None.<br />
To run the internal diagnostics self-tests:<br />
1. Power up the NetTek <strong>Analyzer</strong> Platform.<br />
2. Press File > Exit to quit the <strong>YBA250</strong> application, if it is running.<br />
3. Press Start > Programs > Tektronix Utilities>Diagnostics in the<br />
taskbar.<br />
<strong>YBA250</strong> <strong>Antenna</strong> <strong>and</strong> <strong>Transmission</strong> <strong>Line</strong> <strong>Analyzer</strong> <strong>User</strong> <strong>Manual</strong> E-1
Change language