YBA250 Antenna and Transmission Line Analyzer User Manual

Getting Started
Shutdown Mode
To completely power down the NetTek Analyzer Platform, do the
following:
1. Select Start > Programs > Shutdown.
2. In the Shut Down dialog box, select Shutdown.
A shutdown clears volatile memory, including the YBA250 software
if it is loaded in volatile memory, user setups, and measurement data
not saved to nonvolatile memory. For information on how to save
these items to nonvolatile memory:
1. Select Start > Help.
2. In the Help window select Tektronix Basics.
3. Select Store Data in Nonvolatile Memory.
The next time you press the front-panel power switch, the NetTek
Analyzer Platform cycles through the complete power up process,
taking about 30 seconds to completely power up.
Restart (Software Reset)
If the NetTek Analyzer Platform or YBA250 application stops
responding correctly, try performing a restart to clear the problem.
To restart the YBA250, do the following:
1. Select Start > Programs > Shutdown.
2. In the Shut Down dialog box, select Restart.
The display blanks for approximately five seconds. The YBA250
software reloads and restarts. A restart does not empty volatile
memory.
YBA250 Antenna and Transmission Line Analyzer User Manual 1-13