FinePix S1 Pro Manual - Sensor Cleaning

3 Mounting the Camera Lens
■ Switch the camera “OFF” to mount the camera lens. Always leave the
aperture ring set to the smallest aperture (the aperture setting with the
highest number).
1
Switch the camera off and mount the camera lens.
2
Set
• Align the mounting marks on the lens and the camera body and then turn
the lens slowly in the direction of the arrow until it clicks into place. (Do
not press the lens detaching button.)
• If you switch the camera on when there is no lens mounted or when the
lens mounted is not a Nikkor lens with a built-in CPU (☞ P.107), the “°”
warning appears blinking on the top display panel and in the viewfinder
display and the shutter will not release (If the exposure mode is set to
Manual, the shutter will release when the “°” warning is displayed.)
(☞ P.121).
☞ Note
Notes on Changing the Lens
• Take care not to mount the lens when it is at an angle to the camera as this
can damage the lens mount on the camera.
• Always change the lens in an area free of dirt and dust.
the aperture ring to the smallest aperture and lock
the aperture ring.
• If you switch the camera “ON” when the aperture ring is not set to the
smallest aperture, “‡” appears blinking on the top display panel and in
the viewfinder display and the shutter will not release (☞ P.121).
• Always lock the aperture ring. If the aperture ring slips, the shutter may
not release when you press the shutter button.
20