FinePix S1 Pro Manual - Sensor Cleaning

Rear Display Panel
Setting the Tone
■ Use the procedure below to set the contrast when images are shot.
1
Press the “FUNC” button twice.
2
The icon for the tone setting appears on the rear
display panel. Press function button [2].
With the tone set to “STD”
• The display changes in the cycle shown below each time function button
[2] is pressed.
STD
HARD
ORG
• The same settings can also be selected by holding down function button
[2] and pressing “a” on the 4-direction button. You can select settings in
the reverse order by holding down function button [2] and pressing “b” on
the 4-direction button.
Display Name Description
STD
(default)
HARD
ORG
This setting sets the contrast for photographed images to the
standard level.
Use this setting for images that will undergo image processing
for use in commercial printing. This setting provides a higher
level of contrast than the “STD” setting.
This setting specifies a lower contrast than the “STD” setting.
Use this setting for images that will undergo image processing
for use in commercial printing.
• If you want to view or print the image data directly, do not select “ORG”.
46