KRONOS/KRONOS X Operation Guide - Korg

Loading data from disk Loading Songs, sounds, samples, and KARMA GEs together
Append will leave all currently‐loaded Sampling
Mode, EXs, and User Sample Bank data intact.
Sampling Mode Multisamples and Samples will be
loaded into the next available vacant numbers
following the existing data.
Clear Sampling Mode Data will erase all
Multisamples and Samples from Sampling Mode, and
load the data in the same configuration with which it
was saved. Existing EXs and User Sample Bank data is
left intact.
Clear All is similar to Clear Sampling Mode Data,
above, but also un‐loads existing EXs and User Sample
Bank data before loading the new .KSC file. This frees
up the most memory for the new .KSC.
You can use the information at the bottom of the dialog
box, including Memory Required, (Memory)
Available, and Enough slots for Samples & MS, to
determine whether or not you need to free up room for
the new .KSC.
12.Set the Load Method as desired.
This sets the preferred way to load the EXs and User
Sample Bank data in the KSC: load it into RAM, or use
Virtual Memory. Note that if the data is extremely
large, and would not fit into RAM regardless of which
other samples were loaded, the data will use Virtual
Memory regardless of this setting.
These settings apply only to EXs and User Sample
Banks; Sampling Mode data is always loaded into
RAM.
RAM: The samples will be loaded into RAM. This has
the advantage of allowing reverse playback.
Virtual Memory: The samples will use Virtual
Memory. This generally allows you to load more large
samples at once. Note that the samples may still
require a significant amount of RAM
KSC Settings: KSCs can store separate load method
settings for each Multisample or Drum Sample, based
on the settings when the KSC was saved. Setting Load
method to KSC Settings uses these individual settings.
13.Press the OK button to load the data.
Never remove or disconnect USB storage devices
while data is being loaded.
Loading multiple files at once
You can use “wild cards” to specify multiple .KMP,
.KSF, .AIF, .WAV, SoundFont 2, Akai Program, and
Akai Sample files, and load them simultaneously. For
more information, see “Loading multiple files at once”
on page 837 of the Parameter Guide.
191