HERZ laying system
HERZ laying system
HERZ laying system
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>HERZ</strong> <strong>laying</strong> <strong>system</strong><br />
<strong>HERZ</strong> <strong>system</strong> components for<br />
rolled tacker or folding tacker<br />
insulation<br />
Ready to install thermal insulation and<br />
impact sound attenuation panel made of<br />
foamed polystyrene EPS according to DIN<br />
EN 13163 and DIN 4108 with tear resistant<br />
and water- tight laminated foil and printed<br />
grid pattern.<br />
System roll<br />
Folding panels<br />
Made of EPS-TK according to DIN 18164<br />
part 2. With tear resistant and water- tight<br />
laminated foil and printed grid pattern.<br />
Ultra thin, installation ready thermal<br />
insulation material made out of quality<br />
controlled foamed polystyrene EPS 040<br />
DEO dm according to DIN EN 131163. To<br />
be used underneath screed according to<br />
DIN 18560. Laminated with a tear resistant<br />
and watertight textile fabric composition<br />
foil with printed positioning grid in black.<br />
Overlapping sides to create a better seal<br />
from the screed especially for flowing<br />
screed.<br />
Especially suitable for low height floor<br />
constructions. The <strong>system</strong> design needs to<br />
be checked according to BS EN 1264.<br />
Build height 15 mm<br />
Grid Spacing 50 mm, and multiples<br />
Heat conductivity R = 0.37 m²K/W<br />
Maximum load 100 kPa/m 3<br />
Building material<br />
category B 2 according to DIN 4102<br />
The particular advantage of this <strong>system</strong> is<br />
its very low weight and storage volume.<br />
Tacker-pins<br />
The tacker-pins fix the heating pipes onto<br />
the insulation. Packed with adhesive tape in<br />
30 piece units.<br />
<strong>HERZ</strong> Article No 3 F110 06<br />
Tacker-pins special<br />
Extra long pin shape, made of high quality<br />
polyamide, especially suitable for nonlaminated<br />
surfaces, packed in 30 pieces<br />
<strong>HERZ</strong> Article No 3 F110 07<br />
Folding plate<br />
If necessary an additional insulation layer<br />
can be put underneath the rolled tacker or<br />
folding tacker insulation. The heating pipes<br />
are fixed with fixing-pins at the required<br />
spacing.<br />
The grid printed on to the laminated foil<br />
is very helpful with the positioning the<br />
pipework. The PE foil between the panels is<br />
fused to eliminate any water entry when the<br />
screed is laid.<br />
Rolled Tacker<br />
Installation ready thermal insulation and<br />
impact sound attenuation rolled tacker<br />
insulation made of quality controlled foamed<br />
polystyrene EPS-TK according to DIN 18164<br />
part 2. With tear resistant and water- tight<br />
laminated foil and printed grid pattern.<br />
If necessary a complimentary insulation<br />
layer can be put underneath the rolled<br />
tacker insulation or folding tacker insulation.<br />
The heating pipes are fixed with tacker-pins<br />
at appropriate spacing’s onto the insulation.<br />
The printed grid pattern is very helpful with<br />
pipe spacing during installation. The PE foil<br />
between the panels is fused to eliminate any<br />
water entry when the screed is laid.<br />
Roller mat<br />
Type 15/2 1000 x 10000 mm<br />
Article No 3 F040 01<br />
Type 22/20 1000 x 10000 mm<br />
Article No 3 F040 02<br />
Type 32/30 1000 x 10000 mm<br />
Article No 3 F040 03<br />
Folding panel<br />
Type 15/2 1000 x 2000 mm<br />
Article No 3 F040 04<br />
Type 22/20 1000 x 2000 mm<br />
Article No 3 F040 05<br />
Supplementary required accessories:<br />
• Additional insulation<br />
• Cover foil<br />
• Screed measurement point<br />
• Screed additives<br />
• Edge insulation band<br />
• Expansion joint set<br />
Type 32/30 1000 x 2000 mm<br />
Article No 3 F040 06<br />
www.herz-armaturen.com 17