Spectra 2K User Guide - Spectra Logic
Spectra 2K User Guide - Spectra Logic
Spectra 2K User Guide - Spectra Logic
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Chapter 2. Installing the Library<br />
5. Determine the correct specifications for the SCSI terminator as described in SCSI<br />
Terminator Requirements on page 81. Attach a SCSI terminator to the free SCSI<br />
connector on the library, as shown in Figure 2-5.<br />
Caution: The SCSI bus must be terminated at both ends or unexpected<br />
errors may result. Make sure that the SCSI adapter in the host<br />
computer has the appropriate termination enabled.<br />
Computer<br />
Library<br />
SCSI cable<br />
SCSI cable<br />
Terminator<br />
Figure 2-5 Connect the library to the host computer with the SCSI cable. Connect a SCSI terminator<br />
to the library (as necessary).<br />
6. To attach additional devices to the SCSI bus, continue with Attaching More than<br />
One SCSI Device and complete any further procedures as necessary.<br />
The SCSI card BIOS should display the following information:<br />
SCSI ID: 1 Sony SDX-300C or Sony SDX-500C or Sony SDX-700C<br />
SCSI ID: 2 Sony SDX-300C or Sony SDX-500C or Sony SDX-700C<br />
(if Drive 2 is installed)<br />
SCSI ID: 3 <strong>Spectra</strong> 215<br />
17