Portable DVD/SD/CD Player

Getting Started
12
RQT6912
Preparing the multi cradle and power supply
BEFORE USE
Remove the
insulation sheet
PULL
Make sure the built-in battery is attached
whenever you use the unit.
Multi cradle (AC adaptor)
1 Unwind speaker wire,
then fit the wire back
into the groove of the
speaker base.
2 Twist and pull off the vinyl tip.
3 Connect the speakers.
Y
L
R L R L
COMPONENT VIDEO OUT S VIDEO
AUDIO OUT VIDEO
5.1ch
+
(480P/480I)
OUT
2ch (MIX)
OUT
SUB
+
PBPR WOOFER CENTER SORROUND
FRONT
SPEAKER
SPEAKER
HAUT
HAUT
PARLEUR
PARLEUR
4≠
R
4≠
-
-
Push the levers and insert the wires.
Light gray
Dark gray
DC IN 9V
Ë
No line
Black line
Caution
Use the speakers only with
the recommended system.
Failure to do so may lead to
damage to the connected
equipment and/or the
speakers, and may result in
the risk of fire. Consult a
qualified service person if
damage has occurred or if
you experience a sudden
change in performance.
4 Attach to cradle.
(When the unit is off)
Make sure built-in battery
is attached.
DC IN 9V
DC IN
DC IN 9V Ë
DC IN
2
1
Fit so unit
clicks firmly
into place.
Household AC outlet
(AC 120 V, 60 Hz)
When using only the player
Connect the AC adaptor directly to the player’s
DC IN terminal.
The unit is in the standby condition (the [Í]
indicator lights) when the AC power supply
cord is connected. The primary circuit is
always “live” as long as the AC adaptor is
connected to an electrical outlet.
≥To conserve power
When the unit is not going to be used for a long
time, disconnect the AC power supply cord from
the AC outlet.
The unit consumes a small amount of power
(approx. 0.9 W, when in the multi cradle) when
in standby mode.
∫ To detach
(When the unit is off)
SD CARD : PUSH RELEASE
RELEASE
VIDEO
AUDIO
OPT OUT
Pull the lever so the unit lifts off the cradle.