on page 37 - Aja

24
Please note that KUMO supports both zeroconf Bonjour and UPnP protocols, but does
not require them. For example, you can connect a PC without Bonjour by simply
performing a KUMO default IP address reset and pointing your browser to the address.
Then you can set it up using the KUMO browser UI Network page to set standard TCP/IP
settings (discussed in detail in “TCP-IP Network Connection” on page 27).
If the KUMO will be attached to a WAN, talk to your IT administrator and obtain the details
on how he/she wishes you to configure the KUMO (DHCP or static IP, explained in this
chapter). Manually connecting to a network, you will need to configure the KUMO IP
CONFIG, IP ADDR, IP MASK, and IP GATEWAY parameters according to the information
obtained from your IT administrator in the last step.
Typical System Control Configurations
KUMO networking possibilities range from simple to unlimited because KUMO supports:
• Zeroconf (Bonjour) and UPnP protocols,
• DHCP, or
• Static IP configuration options.
This section describes the following KUMO system network configurations:
• Small Closed or Local network with computer control – zeroconf or UPnP protocol
network, web browser UI control, any number of KUMO routers
• Part of a large LAN/WAN – TCP-IP networking (DHCP or Static IP), web browser UI
control, any number or combination of KUMO routers, web browser control