Installation and Operating Instructions GEN-AUTO Energy Division

More documents

Recommendations

Info

8.2.1 To run the software 1. Press the START icon. 2. Then select Programs\GEN-AUTO (XM)\GEN-AUTO (XM). 3. Then click on GEN-AUTO (XM). 8.3 Description The application has three windows: ● ● Observation Operator Parameters ● Technician Parameters . 38
8.3.1 Observation Window This window shows: Measurement Values: ● Generator Voltage, Generator Frequency ● Engine Speed ● Battery Voltage ● Running Time ● Maintenance Hour 39
Page 1 and 2: Energy Division http://energy.tycoe
Page 3 and 4: Contents Page Section 4 Commissioni
Page 5 and 6: Section 1 Introduction These produc
Page 7 and 8: Figure 2.1 Unit fixing Figure 2.1 F
Page 9 and 10: Figure 2.5 GEN-AUTO single phase co
Page 11 and 12: Table 1 shows the connections and r
Page 13 and 14: 2.4.1 Charge Generator current The
Page 15 and 16: 10. To exit the programming mode, p
Page 17 and 18: Prg Definition of parameter Unit Lo
Page 19 and 20: 3.2.8 Engine started signals (P18)
Page 21 and 22: 2 This is the same as 1 but, in add
Page 23 and 24: Section 5 Operation 5 6 7 5.1 Contr
Page 25 and 26: Control functions: 9. Green LED lig
Page 27 and 28: 6.2.5 Low/High Speed LED This LED f
Page 29 and 30: Section 7 Specification Inputs DC S
Page 31: Section 8 PC Interface 8.1 Introduc
Page 35 and 36: 8.4 Main Menu 8.4.1 File This menu
Page 37 and 38: 8.5 Operation 8.5.1 Accessing Opera
Page 39 and 40: 8.5.4 Saving Parameters to a Config
Page 41 and 42: Programming Reference Sheet Prog No

Installation and Operating Instructions GEN-AUTO Energy Division

Create successful ePaper yourself

Delete template?

Save as template?