Installation and Operating Instructions GEN-AUTO Energy Division

More documents

Recommendations

Info

Section 2 Installation 2.1 Unpacking Carefully unpack the unit and check for damage to the unit or to the cables supplied. Retain the packing in case of future need, e.g. for returning the unit for calibration. Check the contents, as follows: ● ● ● ● One GEN-AUTO Operating Manual Screw clamp electrical connectors Panel mounting clamps Report any shortage or damage to your local sales office as soon as possible. 2.2 Unit Configuration The unit can be programmed using buttons and display on the front panel. Refer to Section 3 Programming for details. Warning : The generator can be started remotely via the Remote Start/Stop input if the Remote Fuel Input is high, irrespective of the position of the Key switch on the front panel of this unit. When using the remote start feature, the installer should connect sound and light warning devices to meet local safety codes and ensure that personnel are warned prior to commencing a remote starting sequence. 2.3 Mechanical Installation The unit is designed for panel mounting. Fixing is by two screw fixings. 1. Remove the fixings from the unit, if fitted, and unscrew the screws in the fixings. 2. Insert the unit in the panel cut-out from the front. Maximum panel thickness is 7 mm (0.28 inch). 3. Insert the fixings in the slots at the diagonal corners of the unit and tighten the fixing screws to secure the unit against the panel. See Figure 2.1. 6
Figure 2.1 Unit fixing Figure 2.1 Front view and Panel cut-out 7
Page 1 and 2: Energy Division http://energy.tycoe
Page 3 and 4: Contents Page Section 4 Commissioni
Page 5: Section 1 Introduction These produc
Page 9 and 10: Figure 2.5 GEN-AUTO single phase co
Page 11 and 12: Table 1 shows the connections and r
Page 13 and 14: 2.4.1 Charge Generator current The
Page 15 and 16: 10. To exit the programming mode, p
Page 17 and 18: Prg Definition of parameter Unit Lo
Page 19 and 20: 3.2.8 Engine started signals (P18)
Page 21 and 22: 2 This is the same as 1 but, in add
Page 23 and 24: Section 5 Operation 5 6 7 5.1 Contr
Page 25 and 26: Control functions: 9. Green LED lig
Page 27 and 28: 6.2.5 Low/High Speed LED This LED f
Page 29 and 30: Section 7 Specification Inputs DC S
Page 31 and 32: Section 8 PC Interface 8.1 Introduc
Page 33 and 34: 8.3.1 Observation Window This windo
Page 35 and 36: 8.4 Main Menu 8.4.1 File This menu
Page 37 and 38: 8.5 Operation 8.5.1 Accessing Opera
Page 39 and 40: 8.5.4 Saving Parameters to a Config
Page 41 and 42: Programming Reference Sheet Prog No

Installation and Operating Instructions GEN-AUTO Energy Division

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?