Installation and Operating Instructions GEN-AUTO Energy Division

More documents

Recommendations

Info

Failures: ● Start Failure ● Low/High Speed ● Low Oil Pressure ● Generator Voltage Failure ● Charge Generator Failure ● High Temperature ● Spare 1-2-3 ● Battery Failure, Weak Battery ● Emergency Stop ● Routine Maintenance Outputs Start Relay Solenoid Relay Configurable Relay Output1 Configurable Relay Output2 Horn Relay 8.3.2 Operator Parameters Window This windows shows the parameters that can be changed by the operator, who must enter the Operator Password stored in the Unit. 8.3.3 Technician Parameters Window This window shows all parameters. Access is obtained by entering the Technician Password stored in the unit. 40
8.4 Main Menu 8.4.1 File This menu allows the user to save and retrieve configuration files to and from the disk. Parameters can also be sent to a printer. Open Save Print Printer Setup Exit Use this option to load parameters into the application from a configuration file on disk. Use this option to save parameters into a configuration file on disk. This option sends the configuration parameters to a printer. This option allows you to select the printer and to change the printer configuration. Use this option to exit the application. 8.4.2 Programming This menu is active while the Operator or Technician Parameters Window is open. It allows you to transfer parameters to and from the unit. Download: Upload: Use this option to download parameters from PC to the unit. Use this option to upload parameters from the unit to the PC. 41
Page 1 and 2: Energy Division http://energy.tycoe
Page 3 and 4: Contents Page Section 4 Commissioni
Page 5 and 6: Section 1 Introduction These produc
Page 7 and 8: Figure 2.1 Unit fixing Figure 2.1 F
Page 9 and 10: Figure 2.5 GEN-AUTO single phase co
Page 11 and 12: Table 1 shows the connections and r
Page 13 and 14: 2.4.1 Charge Generator current The
Page 15 and 16: 10. To exit the programming mode, p
Page 17 and 18: Prg Definition of parameter Unit Lo
Page 19 and 20: 3.2.8 Engine started signals (P18)
Page 21 and 22: 2 This is the same as 1 but, in add
Page 23 and 24: Section 5 Operation 5 6 7 5.1 Contr
Page 25 and 26: Control functions: 9. Green LED lig
Page 27 and 28: 6.2.5 Low/High Speed LED This LED f
Page 29 and 30: Section 7 Specification Inputs DC S
Page 31 and 32: Section 8 PC Interface 8.1 Introduc
Page 33: 8.3.1 Observation Window This windo
Page 37 and 38: 8.5 Operation 8.5.1 Accessing Opera
Page 39 and 40: 8.5.4 Saving Parameters to a Config
Page 41 and 42: Programming Reference Sheet Prog No

Installation and Operating Instructions GEN-AUTO Energy Division

Create successful ePaper yourself

Delete template?

Save as template?