Marine Generator Panda PMS 8 „mini“ E-TEC Icemaster Fischer ...

Generator Failure
10
1. Adjusting screw for upper limitation
2. Speed regulator lever
2
This adjustment should not be changed,
otherwise the warranty expires.
1
C.3.2 Adjustment of the normal speed limitation
Adjusting the lower limitation:
1. Disconnect the plug at the electrical supply line of the actuator.
2. Unclamp the countering nuts with two wrench SW 14.
3. Connect an electrical voltage instrument (voltmeter) with a display range until 300V AC to AC
outlet in the elektrical cabinet.
4. Be sure that no electrical load is adjusted.
5. Start the generator.
6. Decrease the rev of the generator by turning the spindle of the actuator manually until the voltmeter
reach a value of 230V.
7. Both nuts must be screwed tight.
8. Check again if the lower voltage of the generator is limited to min. 230V without load.
Adjusting the upper limitation:
1. Proceed like before and tighten the countering nuts at a voltage of max. 270V without load.
2. Check again if the upper voltage of the generator is limited to this value.
14
1. Adjusting nut for upper speed limitation
2. Adjusting nut for lower speed limitation
1 2
Page 34
Panda PMS 8 "mini" E-TEC s00585 - Chapter C: Generator Failure