You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Connections<br />
■ Before connecting to the SPEAKERS<br />
terminal<br />
A speaker cord is actually a pair of insulated cables<br />
running side by side. Cables are colored or shaped<br />
differently, perhaps with a stripe, groove or ridges.<br />
Connect the striped (grooved, etc.) cable to the “+” (red)<br />
terminals of this unit and your speaker. Connect the plain<br />
cable to the “–” (black) terminals.<br />
Remove approximately 10 mm (3/8”) of insulation<br />
from the end of each speaker cable and then<br />
twist the bare wires of the cable together to<br />
prevent short circuits.<br />
■<br />
10 mm (3/8”)<br />
Connecting to the SPEAKERS terminals<br />
Setting the speaker impedance<br />
(U.S.A. and Canada models only)<br />
Caution<br />
If you are to use 6 ohm speakers, set “SP IMP.” to “6Ω<br />
MIN” as follows BEFORE using this unit.<br />
1 Make sure this unit is turned off.<br />
See page 19 for details about turning on or off this<br />
unit.<br />
2 Press and hold 0TONE CONTROL and<br />
then press 1STANDBY/ON to turn on this<br />
unit.<br />
This unit turns on, an the advanced setup menu<br />
appears in the front panel display.<br />
PREPARATION<br />
1<br />
3<br />
2<br />
Red: positive (+)<br />
Black: negative (–)<br />
3 Press APROGRAM l / h repeatedly to<br />
select “SP IMP.”.<br />
The following display appears in the front panel<br />
display.<br />
SP IMP.- 8 MIN<br />
1 Loosen the knob.<br />
2 Insert the bare end of the speaker wire into<br />
the hole on the terminal.<br />
4 Press BSTRAIGHT repeatedly to select “6Ω<br />
MIN”.<br />
The following display appears in the front panel<br />
display.<br />
3 Tighten the knob to secure the wire.<br />
Connecting the banana plug<br />
(except Korea and Asia models)<br />
The banana plug is a single-pole electrical connector<br />
widely used to terminate speaker cables. First, tighten the<br />
knob and then insert the banana plug connector into the<br />
end of the corresponding terminal.<br />
Banana plug<br />
5 Press 1STANDBY/ON to confirm your<br />
selection and set this unit to the standby<br />
mode.<br />
Note<br />
SP IMP.- 6 MIN<br />
The setting you made is reflected next time you turn on this unit.<br />
English<br />
13 En