Model 24927 - Ready Remote

Crimp your spade connector to the hood pin wire, and run the wire
into the vehicle's passenger compartment through a factory rubber
grommet (at the same time you might want to run the Tachometer
Input wire and Horn output wire from the Optional Harness
through the fire wall as you may need to connect them using the
following steps).
Using a sharp, pointed object, poke a hole into the grommet
(being careful not to damage any existing wires in the grommet)
and attach the wire to the object with electrical tape. Pull the
wire through the grommet, taking extra care to keep the wire away
from any moving parts or anything that will generate extreme
heat.
An alternative to this method would be to find a spot on the firewall
with sufficient clearance on both sides and drill an access
hole through the firewall. Take note of what is directly on the
other side of where you are drilling as to not puncture brake cylinders,
computers, etc. Once the wire is run into the vehicle and
secured from any moving parts, solder the wire to the VIOLET wire
of the 6-pin harness and wrap the connection with electrical tape.
WARNING! This wire MUST be connected. Do not
use the vehicle until you confirm the operation
of the hood pin shutdown. Improper operation
could result in serious injury or death.
26 © 2007 Directed Electronics