Model 24927 - Ready Remote

More documents

Recommendations

Info

Neutral Safety Test Some vehicles do not have an electrical neutral safety switch. Instead, a mechanical neutral safety switch that physically interrupts the starter wire is used when the vehicle is in any drive gear. If the remote start is interfaced before this switch, it will provide protection from starting in gear. However, some vehicles combine the column shift mechanism and the mechanical neutral safety switch into one mechanical part. In these vehicles, it is impossible to interface the remote start system before the neutral safety switch. With this type of vehicle, if the car is left in a drive gear and the remote start system is activated, the vehicle will move and may cause damage to persons or property. Important! This test must be performed to determine if the vehicle will start while in gear. If the vehicle attempts to start during this test you must call Technical Support at 1-800-477-1382 for assistance before using the remote start feature. Testing the Neutral Safety Switch Note! You must complete the remote start system installation before doing the following test. Ensure that the remote start system is functioning normally. This includes connecting to the brake as a shut-down. 1. Make sure there is adequate clearance to the front and rear of the vehicle because it may move slightly. © 2007 Directed Electronics 69
2. Make sure the hood is closed and there are no remote start shut-downs active. 3. Set the emergency brake. 4. Turn the key to the "run" position, this will release the shifter. 5. Place the shifter in the drive position. 6. Place your foot directly over the brake pedal, but do not depress it. Be ready to step on the brake if the starter engages. 7. Activate the remote start system. 8. If the starter does not engage, no additional safety interfaces are required. 9. If the starter engages, immediately depress the brake to shut the remote start system down. IF THE ENGINE ATTEMPTED TO START THE VEHICLE, THEN THE VEHICLE HAS FAILED THE TEST CALL TECHNICAL SUPPORT FOR ASSISTANCE AT 1-800-477-1382 Warning! If the vehicle fails this test, the remote start must be disabled until the proper Safety Interface has been installed that will keep the vehicle from starting while in gear. Failure to do so may result in property damage, injury or death. 70 © 2007 Directed Electronics
Page 1 and 2:
Model 24927 ➤Owner’s/Installati
Page 3 and 4:
Consumer's remedy is limited to rep
Page 5 and 6:
6 © 2007 Directed Electronics
Page 7 and 8:
Important Information Congratulatio
Page 9 and 10:
2. When parking in an enclosed or p
Page 11 and 12:
H1 Harness - 6 pin connector H1/1 H
Page 13 and 14:
H3 harness - 3 pin connector H3/1 H
Page 15 and 16:
Step 1, Heavy Gauge Wire Connection
Page 17 and 18: With the key in the off position, t
Page 19 and 20: Accessory and Starter Wires The sta
Page 21 and 22: Many Nissan and Toyota vehicles hav
Page 23 and 24: Parking Light Flash There are sever
Page 25 and 26: Crimp your spade connector to the h
Page 27 and 28: All other door lock systems will re
Page 29 and 30: Important: Remember that these wire
Page 31 and 32: Type C: Direct-wired reversing pola
Page 33 and 34: Type D: Adding one or more aftermar
Page 35 and 36: Type F: One-wire system - cut to lo
Page 37 and 38: Determining the Proper Resistor Val
Page 39 and 40: Determining the Proper Resistor Val
Page 41 and 42: Tachometer Wire WARNING! In the fol
Page 43 and 44: Following is a brief description of
Page 45 and 46: Headlight Control wire The Yellow/B
Page 47 and 48: 48 © 2007 Directed Electronics
Page 49 and 50: Step 7, Programming Programming tra
Page 51 and 52: Transmitter Button Programming Char
Page 53 and 54: 3. Press a button on the transmitte
Page 55 and 56: Feature Menu 1 Descriptions 1. Engi
Page 57 and 58: 2. Siren: The output will be consta
Page 59 and 60: 2. Locking Type: Selects the type o
Page 61 and 62: 10. Alarm Chirps: Selects if the "B
Page 63 and 64: Alarm Input Chart LED Flashes Input
Page 65 and 66: Last Start Diagnostics: The system
Page 67: Testing the System Once steps 1-7 h
Page 71 and 72: ➜ The remote start will not activ
Page 75 and 76: ➤ ➤ ➤ ➤ ➤ Trunk release o
Page 77 and 78: Note! If the lights flash more than
Page 79 and 80: flashing to indicate Quick Stop Mod
Page 81 and 82: Note! The alarm functions will be f
Page 83 and 84: Auto-rearming feature Auto-rearming
Page 85 and 86: To activate Panic Mode: ➤ Press a
Page 87 and 88: Convenience Features Carfinder Feat
Page 89 and 90: Glossary of Terms Control Module: T
Page 95: The company behind this system is D
show all

Model 24927 - Ready Remote

Create successful ePaper yourself

Delete template?

Save as template?