Download Manual - Silvan Australia
Download Manual - Silvan Australia
Download Manual - Silvan Australia
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Optional Equipment<br />
The following optional equipment is normally<br />
factory fitted at the time of manufacture but can<br />
also be installed during the life of the sprayer.<br />
Contact your <strong>Silvan</strong> dealer for further information<br />
about installation during service life.<br />
Foam Marker<br />
The foam marker is used to identify the sprayed<br />
area. The system generates foam at the end of the<br />
boom from diluted foam solution and air, pumped<br />
separately through small bore hoses. This<br />
produces superior quality foam by avoiding the<br />
deterioration that can occur from heat and vibration<br />
when foam is pumped through long hoses.<br />
Diluted foam concentrate from a 100 litre tank is<br />
forced by air pressure to the boom. A needle valve<br />
is used to regulate the flow rate. The 12 volt<br />
compressor generates a large volume of air at low<br />
pressure. A safety valve is incorporated in case a<br />
hose is accidentally kinked or blocked.<br />
A selector switch on the control box or the electric<br />
over hydraulic boom control, if fitted, operates<br />
electric solenoid valves that direct air and foam<br />
solution to a foam generating chamber and<br />
dropper at either the left or right end of the boom.<br />
A mesh screen in the generator aids foam control.<br />
Full installation and operating details are given in<br />
the Operators <strong>Manual</strong> supplied with the unit.<br />
Lock Nut<br />
Filler Cap<br />
Fluid Flow<br />
Knob<br />
Pressure<br />
Relief Valve<br />
Left or Right<br />
Indicator Lights<br />
Left/Off/Right<br />
Selector Switch<br />
FOAM MARKER CABIN CONTROL<br />
Not used with Electric over Hydraulic Boom Controls<br />
Primo 400 Farmscan Spray Controller<br />
The controller can be fitted to automatically<br />
maintain the required chemical application rate to<br />
maximise spraying efficiency. It includes switches<br />
for a four section boom and can be set to cease<br />
spraying when speed falls below a selected figure.<br />
The unit monitors and displays a continuous digital<br />
read out of critical spraying information by means<br />
of a single function display that can be switched<br />
between a number of factors, including:<br />
• Application rate.<br />
• Flow rate.<br />
• Ground speed.<br />
• Area sprayed.<br />
• Distance travelled.<br />
• Chemical volume used.<br />
Full installation and operational details are given in<br />
the Operator’s <strong>Manual</strong> supplied with the controller.<br />
Digital Display<br />
Air Pressure<br />
Gauge<br />
Contents<br />
Sight<br />
Line<br />
Air<br />
Compressor<br />
Filter<br />
Boom<br />
Section<br />
Switches<br />
Foam<br />
Solution<br />
Tank<br />
Air Compressor<br />
Boom Master<br />
Switch<br />
Computer<br />
Power Switch<br />
FOAM MARKER<br />
FARMSCAN PRIMO 400 SPRAY CONTROLLER<br />
28