1-2066FA INSTALL INSTRUCTIONS - Classic Auto Air

More documents

Recommendations

Info

PAGE 20 OFF HEAT DEF DASH FLOOR DEF F A N We’ve included enough extra cable length to allow you to mount the ECU in a variety of places. It is very important that you mount this in a place where it will stay dry and that vibration is at a minimum. Also make sure that where ever you mount it it does not interfere with any moving controls or cables. We recommend mounting it just above the right hand side of the main unit using the included tek-screws. IMPORTANT! DON’T MOUNT THE ECU PERMANENTLY JUST YET. THAT CAN BE DONE AFTER YOU CALIBRATE THE UNIT . In Bag Kit D you will find three wiring harnesses with connections at each end. Plug the harness with YELLOW band into the YELLOW ECU port and the other end into the servo motor on the main unit (motor is marked with YELLOW INDICATOR). Repeat this process for the other two harnesses, following the color coding indicated on cables and ports. Attach cable in the engine compartment to the electronic water valve and route to one of the unused holes from the OEM unit. CONTROL HEAD: The GREEN harness connection will be made to the blower switch on the control head. Attach the connection to the blower switch, then insert the control head back into the dash and secure with the OEM screws. Make the final conection to the ECU at the GREEN port. Seal around the tubes with the included refrigerant tape. This will keep unwanted moisture and debris from entering thru the firewall... so seal carefully and thoroughly. www.classicautoair.com • 866.435.7801
PAGE 21 Wiring Diagram/Overview To 12V Power Supply (min. 20 amp fuse) Orange Harness Electronic Water Valve Red/White Wire Compressor Blower Switch Green Harness Blue Wires Ground Pressure Switch White Wire ECU D.E.R. Yellow Harness Servo for Face/Floor Ducts Blue Harness Evaporator Thermostat Ground Blue Wire Relay Red Wire Blue Wire Servo for Defrost Ducts Blue Wire Ground REMINDER: BE SURE THAT THE WIRING HARNESS DOES NOT INTERFERE WITH THE OPERATION OF ANY CONTROLS. www.classicautoair.com • 866.435.7801
Page 1 and 2: Installation Manual 1968-1970 MOPAR
Page 3 and 4: PAGE 3 You have just purchased the
Page 5 and 6: PAGE 5 A Basic Overview of Automoti
Page 7 and 8: PAGE 7 Remove Glove box, Glovebox d
Page 9 and 10: PAGE 9 THESE ARE THE PARTS YOU WILL
Page 11 and 12: PAGE 11 THESE ARE THE PARTS YOU WIL
Page 13 and 14: PAGE 13 A FIGURE 7 Locate the fresh
Page 15 and 16: PAGE 15 We’ve included a new unde
Page 17 and 18: PAGE 17 In Bag Kit C you’ll find
Page 19: PAGE 19 THESE ARE THE PARTS YOU WIL
Page 23 and 24: PAGE 23 Temporarily reconnect the c
Page 25 and 26: PAGE 25 Bag Kit E: The following st
Page 27 and 28: PAGE 27 LOUVER FLEX HOSE ROUTE CENT
Page 29 and 30: PAGE 29 THESE ARE THE PARTS YOU WIL
Page 31 and 32: PAGE 31 STEP FIVE: You can perform
Page 33 and 34: PAGE 33 STEP NINE: CONNECTING THE H
Page 35 and 36: PAGE 35 www.classicautoair.com •
Page 37 and 38: PAGE 37 TEST CONDITIONS USED TO DET
Page 39: THIS TEMPLATE IS USED FROM THE INSI

1-2066FA INSTALL INSTRUCTIONS - Classic Auto Air

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?