MP3000E Series USER MANUAL - CandCNC

More documents

Recommendations

Info

MP3000 OPTIONS As part of our TOTAL MODULAR SYSTEM CandCNC has developed a product line to make interface to Gecko drives a single cable project. The MTA100 card is the interface to the EZPLug Stepper Interface Card and/or the EZPlug Servo Interface card. The following pages show the most common connections and setups for building an integrated Gecko based Controller. The MP3000 becomes the front end interface to the PC and supports expansion options like Digital Torch Height Control and Isolated Spindle Speed Control. Because MACH and the MP3000 use Step & Direction signaling the type of motor is completely dependant on the Motor Drive. Our Interface cards make it easy to connect any Gecko 200 series (except the 250 and 251) or 300 series servo drives. You can even choose to run a mixed system of steppers and servo motors. The optional Gecko Mounting plates allow you to build 4 (or up to 6 with Triple Stack version) Drive stacks. The plates act as heatsinks and mounting for both the Gecko and the EZPlug card and the drive connectors stick out the opposite side to make hooking up motors (and encoders on servos) a 2 second process. If you would like more information about the EZPlug series of cards and plates visit http://www.CandCNC.com and Select MODULAR BLOCKS from the top tabs.
1 2 1 2 1 MTA100 Mass Termination Adapter PC withMACH3 Quick and Easy 3 or 4 axis Controller Parallel Port NOT TO SCALE GECKO CandCNC 10 pin ribbon cables 10” DB25
Page 1 and 2: MP3000E Series USER MANUAL Includin
Page 3 and 4: Push Read Optional PORT2 Expansion
Page 5 and 6: INSTALL and SETUP PRIMARY and/or SE
Page 7 and 8: INSTALL MACH SOFTWARE Software Inst
Page 9 and 10: Tree structure of Support CD: Root
Page 11 and 12: Setting up and confirming Parallel
Page 13 and 14: PC Single DB9 Cable Parallel Ports
Page 15 and 16: HARDWARE SETUP Plugging in Universa
Page 17 and 18: Push Read Plugging in the Internati
Page 19 and 20: Installing the Table I/O Card. We h
Page 21 and 22: C5 C8 C7 C6 J2 Xhome YHome ZHome LI
Page 23 and 24: USING OUTPUT RELAYS TABLE IO CARD I
Page 25 and 26: PLUG X - Y 1 J5 1 2 1 Z - A J19 S&D
Page 27 and 28: 1 2 1 2 1 X MOTOR X Encoder MTA100
Page 29: PINOUT INFORMATION for MTA100 and M
Page 33 and 34: EXPLODED VIEW GECKO TRIPLE STACK MO
Page 35 and 36: 1 1 TO MTA100 MP3000 INTERNALS TABL
Page 37 and 38: 1 1 INSTALLING THE DTHC INTO AN EXI
Page 39 and 40: IMPORTANT NOTE ON INTERNAL PLUGS: T
Page 41 and 42: For proper tuning of MACH3 please r
Page 43 and 44: The MDI is a line to allow you to t
Page 45 and 46: Confirming proper operation 1. With
Page 47 and 48: Once you have the motors moving the
Page 49 and 50: ADDENDUM SECTION PINOUT CHARTS BL
Page 51 and 52: PINOUT CHART for MTA100 & MTA150 ca
Page 53 and 54: PIN IDENTIFIER for DB25 & DB 9 Conn

MP3000E Series USER MANUAL - CandCNC

Create successful ePaper yourself

Delete template?

Save as template?