MP3000E Series USER MANUAL - CandCNC

More documents

Recommendations

Info

Running the first test cut. To save frustrations and money do your first G-code run with the Z zeroed a n inch or two above actual material/table height. Open the G-Code folder in MACH and run the RoadRunner.tap file but using the File Load G-code option. Watch it cut air and make the moves. If you want to have some fun tape down a large piece of pape or cardboard and chuck a marker into the Z head and reset the Z zero so that when the marker tip is touching the Z DRO reads -.100 inches. Run the RoadRunner again TESTING The DTHC Digital Torch Height Control or the ISS-02 Spindle Speed Modules have their own setup and operation Manuals. You should first run the auto installs for those devices. It will setup a new profile and load different screen sets. You should be aware that each MACH profile has it’s own settings including all of the motor tuning and homing, hotkeys, etc. To get those settings into a new profile open the working profile you just completed and either write down the settings or do screen grabs you can refer to. Transfer all of the settings to your new profile. AT THIS POINT YOU SHOULD REFER TO THE APPROPRIATE <strong>MANUAL</strong>S IF You have an Expansion Module or Option not covered in this manual See the Manuals Section of the CD for specific product manuals. You can also find manuals on our website at http://www.<strong>CandCNC</strong>.com/Manuals.htm
ADDENDUM SECTION PINOUT CHARTS BLOCK SCHEMATIC (UBOB)
Page 1 and 2: MP3000E Series USER MANUAL Includin
Page 3 and 4: Push Read Optional PORT2 Expansion
Page 5 and 6: INSTALL and SETUP PRIMARY and/or SE
Page 7 and 8: INSTALL MACH SOFTWARE Software Inst
Page 9 and 10: Tree structure of Support CD: Root
Page 11 and 12: Setting up and confirming Parallel
Page 13 and 14: PC Single DB9 Cable Parallel Ports
Page 15 and 16: HARDWARE SETUP Plugging in Universa
Page 17 and 18: Push Read Plugging in the Internati
Page 19 and 20: Installing the Table I/O Card. We h
Page 21 and 22: C5 C8 C7 C6 J2 Xhome YHome ZHome LI
Page 23 and 24: USING OUTPUT RELAYS TABLE IO CARD I
Page 25 and 26: PLUG X - Y 1 J5 1 2 1 Z - A J19 S&D
Page 27 and 28: 1 2 1 2 1 X MOTOR X Encoder MTA100
Page 29 and 30: PINOUT INFORMATION for MTA100 and M
Page 31 and 32: 1 2 1 2 1 MTA100 Mass Termination A
Page 33 and 34: EXPLODED VIEW GECKO TRIPLE STACK MO
Page 35 and 36: 1 1 TO MTA100 MP3000 INTERNALS TABL
Page 37 and 38: 1 1 INSTALLING THE DTHC INTO AN EXI
Page 39 and 40: IMPORTANT NOTE ON INTERNAL PLUGS: T
Page 41 and 42: For proper tuning of MACH3 please r
Page 43 and 44: The MDI is a line to allow you to t
Page 45 and 46: Confirming proper operation 1. With
Page 47: Once you have the motors moving the
Page 51 and 52: PINOUT CHART for MTA100 & MTA150 ca
Page 53 and 54: PIN IDENTIFIER for DB25 & DB 9 Conn

MP3000E Series USER MANUAL - CandCNC

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?