Installation & Operation Manual - Phase-A-Matic, Inc.
Installation & Operation Manual - Phase-A-Matic, Inc.
Installation & Operation Manual - Phase-A-Matic, Inc.
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Note: See Engine Controller manual for additional information.<br />
Table 5-3 Troubleshooting Guide (Analog Controller Only)<br />
Problem Possible Cause Remedy<br />
Controller cannot be Reset"<br />
Engine alarms are ON for high engine<br />
temperature or low oil pressure when<br />
engine is operating properly<br />
Overspeed shutdown occurs at normal<br />
speed<br />
Engine not stopped<br />
Controller not in OFF mode<br />
Sending unit is disconnected (open<br />
circuit)<br />
Defective sending unit<br />
Controller has failed or input from<br />
Magnetic pickup is incorrect.<br />
Verify the engine is at a complete stop before trying to reset.<br />
Set the controller to the OFF mode before trying to reset.<br />
Verify the sending units wiring to controller terminals is not open or<br />
shorted.<br />
Verify the engine mounted senders have correct resistance values<br />
for corresponding input temperature or pressure.<br />
Verify the adjustments. Replace controller if failed.<br />
Service<br />
Parts<br />
Service for your generator can be obtained from Baldor Generators. Please have the following<br />
information available prior to contacting the factory:<br />
The model number and serial number of the generator set.<br />
A complete and accurate description of the problem.<br />
Parts for your generator can be obtained from Baldor Generators. Please have the following<br />
information available prior to contacting the factory:<br />
The model number and serial number of the generator set.<br />
A complete and accurate description of the part (part number if known).<br />
Note: Engine parts can usually be obtained from a local distributor by using the information in<br />
the engine manufacturer’s owner’s manual.<br />
5-4 Troubleshooting and Maintenance MN2415