Installation & Operation Manual - Phase-A-Matic, Inc.

Appendix D
Series AE25
Information in this Appendix applies to the AE25 Generator.
Operator Panel Configuration
Figure D-1 AE25 Operator Panel
WATER
OIL
HIGH TEMPERATURE
LOW OIL PRESSURE
OVERSPEED
OVERCRANK
Hour Meter
BATTERY
MANUAL
RUN
STOP
MASTER
CONTROL
AUTO
START
DC CONTROL FUSE AC CONTROL FUSE
NAT. GAS
L.P. GAS
Display Lamps
Hour Meter
Meters
DC Control Fuse
AC Control Fuse
High Temperature − Indicates excessive engine coolant temperature.
Low Oil Pressure − Indicates low engine oil pressure.
Overspeed − Indicates engine speed is greater than preset limit.
Overcrank − Failure of the engine to start by the end of the crank period results in
an “overcrank” shutdown and alarm indication.
Displays total hours of operation based on power applied to Fuel Solenoid).
Water − Displays the temperature of the engine coolant.
Oil − Displays the engines oil pressure.
Battery − Displays the battery voltage of the starting battery.
Fuse for engine controller.
Fuse for engine controller.
Master Control Switch
Stop
Stops the Engine and generator set.
Manual Run Immediately energizes the crank cycle to start the generator set and produce power.
Auto Start The engine can only be started by making a connection across the remote start terminals of the
control box. This allows normal automatic backup operation of the Generator Set under control of
the Transfer Switch whenever utility AC power is lost.
Natural/LP Gas Selector Switch
Selects the correct fuel source: Natural Gas or L.P. Gas.
MN2415
Series AE25 D-1