Technical Specification for - Gujarat Electricity Board

TECHNICAL SPECIFICATION FOR
SDH/PDH Equipment with integrated Access Multiplexer
2.13 SPECIAL CONDITION TO BIDDER:
1 The installation & commissioning of FOTE equipments will require to be carried out
stage wise depending on the readiness of the transmission lines with OPGW and
building of Sub-stations between which lines will be terminated. Hence in the
context of above bidder shall have to specify the special storage condition if
required.
2. The bidder shall furnish the full technical details & drawings for the offered SDH
(STM -1) equipment with integrated Access Multiplexer.
3. The testing of all FOTE equipments for stipulated requirements, ultimate system
capacity supported as per technical specification complete with path protection and
testing of signals for ring topology arrangement shall be responsibility of the bidder.
Also the bidder shall have to ensure for correctness of the operation of the FOTE
equipments which will require to be connected in ring topology for various
applications viz. Speech and Data communication, teleportection signal
transmission/reception and SCADA connectivity as per Technical Specification.
4. The successful bidder shall have to submit the documents covering the details of
various tests to be done for each FOTE with procedure, test set up, connection
diagram and table to record test results obtained against the required value of test
parameter.
5. The bidder shall have to submit the working diagram for the NMS system
comprising various nodes of the OPGW network: Network Layout (copy enclosed)
showing connection diagram with details of interface port from central control
stations to nodes of the network.
6. The bidder shall have to arrange for imparting training free of cost including cost of
logistics and accommodation to at least TEN (10) technical official of GETCO
covering complete installation & commissioning procedure, working functionality of
different modules, supporting software installation & management (both EMS &
NMS), Handling the equipments ( both hardware & software configuration), fault
diagnosis & attending etc. In the event of order bidder shall have to get approval of
training literature/documents from GETCO.
7. The bidder shall have to supply LCT – Local Craft terminal- 11 Nos., i.e. laptop (as
per specification enclosed) along with EMS free of cost under this package.
8. After submission of bids, each bidder will have to make a detailed technical
presentation (2 to 3 Hrs.) on the solution offered explaining advantages &
disadvantages to GETCO authorities to enable GETCO to understand the complete
offering by the bidder at no extra cost to GETCO.
9. Any deviation shall be clearly indicated separately.
10. The GETCO reserves right to increase or decrease the quantity at the time of
placing the order.
11. The GETCO reserve right either to accept or reject any of the offers without
assigning the reason.
Sign & Seal of Bidder
GETCO/E/TS-SDH/PDH FOTE/R1, Dt:16.04.2011
Page 52 of 60